Loading ...
Loading ...
Loading ...
English 15
INSTALLATION
Installing the charging stand
Installation guide
2
3
4
1
'Click'
Assembling the charging stand
1 Assemble the stand pipe to the bottom
support, and x it with a screw (small).
– Make sure the direction for the
assembly is correct and push it in rmly
so that the screw hole is made correctly.
2 Assemble the vacuum charging part to
the top of the stand pipe.
– Do not disassemble it after the
assembly.
3 Connect the power cord to the rear of the
charging stand.
– Hold the connection part of the cord
and push it onto the connection pins
rmly until the gray lines on the tip of
the cord are not visible.
– When inserting the cord into the
groove on the bottom of the bottom
support, charging stand can be installed
close against the wall.
4 Plug in the charging stand.
2
3
4
1
66cm60cm
Fixing by the hook
1 Using the xing hook as a template, mark
where the top and bottom screw holes
will be placed on the wall.
– Top: 66 cm from the oor
– Bottom: 60 cm from the oor
2 Drill the holes using a 6 mm drill bit, and
put the provided screw anchors into the
hole.
3 Fix the xing hook to the wall with the
provided screws (large).
4 Hook the groove of the charging stand
into the xing hook.
Please refer to the QR code for detailed information on the installation and
charging method of the charging stand.
VS9000_EN_00821F-01_SA_NEW.indd 15 2019-09-04 오후 10:42:56
Loading ...
Loading ...
Loading ...