Loading ...
Loading ...
Loading ...
User Manual esatto.house 14 15
Upper filter
(take out)
lower filter B
(take out)
lower filter A
(Press the grill down
slightly and pull the lower
filter A out at the same time)
Uper air filter
(take out)
Lower air filter
(take out)
WARNING:
• Always unplug the unit before cleaning or servicing.
• DO NOT use ammable liquids or chemicals to
clean the unit.
• DO NOT wash the unit under running water. Doing
so causes electrical danger.
• DO NOT operate the machine if the power supply
was damaged during cleaning. A damaged power
cord must be replaced with a new cord from the
manufacturer.
• Clean the Air Filter
IMPORTANT:
DO NOT operate the unit without lter because dirt
and lint will clog it and reduce performance.
CLEAN THE UNIT
Clean the unit using a damp, lint-free cloth and mild
detergent. Dry the unit with a dry, lint-free cloth.
Store the unit when not in use
• Drain the unit’s water collection tray according to
the instructions in the following section.
• Run the appliance on FAN mode for 12 hours in a
warm room to dry it and prevent mold.
• Turn o the appliance and unplug it.
• Clean the air lter according to the instructions in
the previous section. Reinstall the clean, dry lter
before storing.
• Remove the batteries from the remote control.
Be sure to store the unit in a cool, dark place.
Exposure to direct sunshine or extreme heat can
shorten the lifespan of the unit.
NOTE: The cabinet and front may be dusted with an
oil-free cloth or washed with a cloth dampened in a
solution of warm water and mildliquid dishwashing
detergent. Rinse thoroughly and wipe dry. Never use
harsh cleansers, wax or polish on the cabinet front.
Be sure to wring excess water from the cloth before
wiping around the controls. Excess water in or
around the controls may cause damage to the unit.
Operation Instructions (Continued)
OTHER FEATURES:
FOLLOW ME/TEMP SENSING feture(optionl)
NOTE: This feature can be activated from the remote
control ONLY. The remote control serves as a remote
thermostat allowing for the precise temperature control
at its location. To activate the Follow Me/Temp Sensing
feature, point the remote control towards the unit and
press the Follow Me/Temp Sensing button. The remote
control will send this signal to the air conditioner until
press the Follow Me/Temp Sensing button again. If
the unit does not receive the Follow Me/Temp Sensing
signal during any 7 minutes interval, the unit will exit the
Follow Me/Temp Sensing mode.
NOTE: This feature is unavailabe under FAN or DRY mode.
AUTORESTART MAY NOT BE APPLICABLE
If the unit breaks o unexpectedly due to the power
cut, it will restart with the previous function setting
automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted
operation in the rst 3 minutes. This is to protect the
unit. Operation will automatically start after 3 minutes
AIR FLOW DIRECTION ADJUSTMENT
• The louver can be adjusted automatically. Adjust
the air ow direction automatically (NOTE:On some
models the louver can be adjusted manually only)
• When the Power is ON, the louver opens fully.
• Press the SWING button on the panel or remote
controller to initiate the Auto swing feature. The
louver willl swing up and down automatically.
• Please do not adjust the louver manually.
POWER MANAGEMENT FEATUREOPTIONAL
When the ambient temperature is lower than the
setting temperature for a period of time, the unit will
be automatically operate power management feature.
The compressor will stop, then the fan motor for some
models may stop. When the ambient temperature is
higher than the setting temperature, the unit will be
automatically quit the power management feature.
The compressor and fan motor run.
WATER DRAINAGE
During dehumidifying modes, remove the upper
drain plug from the back of the unit, install the drain
connector (5/8” universal female mender) with 3/4”
hose (locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Place
the open end of the hose directly over the drain area in
your basement oor.
During heating pump mode, remove the lower drain plug
from the back of the unit, install the drain connector(5/8”
universal female mender) with 3/4” hose (locally purchased).
For the models without drain connector, just attach the drain
hose to the hole. Place the open end of the Hose adaptor
directly over the drain area in your basement oor.
NOTE: Make sure the hose is secure so there are no leaks.
Direct the hose toward the drain, making sure that there
are no kinks that will stop the warter owing.Place the
end of the hose into he drain and make sure the end of
the hose is down to let the water ow smoothly. (See
Figs with
✓ ). Do never let it up. (See Figs with ✕ ).When
the continuous drain hose is not used, ensure that the
corresponding drain plug and knob are installed rmly to
prevent leakage.
When the water level of the bottom tray reaches
a predetermined level, the unit beeps 8 times, the
digital display area shows “P1” . At this time the air
conditioning/dehumidication process will immediately
stop. However, the fan motor will continue to
operate(this is normal). Carefully move the unit to a
drain location, remove the bottom drain plug and let the
water drain away. Reinstall the bottom
drain plug and restart the machine
until the “P1” symbol disappears. If the
error repeats, call for service.
NOTE: Be sure to reinstll the bottom
drin plug rmly to prevent lekge
before using the unit.
Remove the
upper drain plug
Continuous
drain hose
Remove the
upper drain plug
Continuous
drain hose
✓ Model B✓ Model A
✓ Model B✓ Model A
drain hose
adaptor
Continuous
drain hose
Remove the
lower drain plug
Continuous
drain hose
Remove the
lower drain plug
Press the power
cord buckle into
the rear cover.
delivery lift <1.8m
drain hose
adaptor
drain hose
adaptor
Maintenance
Model BModel A
Remove the air lter
Loading ...
Loading ...
Loading ...