Loading ...
Loading ...
Loading ...
5
MOUNTING AND INSTALLATION
The diagram below shows a typical
mounting procedure into a fiberglass
panel. Always follow proper safety
procedures. Wear eye-protection
at all times with a dust mask and
gloves when cutting. A mounting
template is included to aid in
measuring and marking the mounting
surface before cutting or drilling.
1. Press along the perforation to
remove the center section of the
mounting template. (Discard the
center section.) The template can
be used to verify there is sufficient
flat surface area for mounting
and as a guide for cutting the
opening. Tape the template
to the mounting location and
mark the surface for cutting the
opening and drilling pilot holes.
2. Use a jigsaw or rotary tool to cut an
opening in the mounting surface.
If necessary, use a file or sandpaper
to adjust the opening for proper
fitment and smooth the edges.
3. Place the MM100s-BE into the
opening and check that the
mounting holes remain aligned
with the pilot hole marks taken
from the template. If not, adjust
and mark new holes as necessary.
4. Remove the MM100s-BE and drill
four (4) pilot holes in the mounting
surface at the pilot hole marks.
5. Peel the adhesive backing
from the mounting gasket and
affix to the rear of the bezel.
Connect all wiring and place the
MM100s-BE into the opening.
6. Secure the MM100s-BE using the
four (4) stainless steel screws.
Press the trim ring onto the
front of the MM100s-BE.
Before drilling or cutting, make
sure there is adequate space behind
the mounting surface to fit the
MM100s-BE, including its
wire harness.
Loading ...
Loading ...
Loading ...