Loading ...
Loading ...
Loading ...
EN - 9
EN
USE (Fig. 1)
Recommendations for use
The result of the milk mount function
can be influenced by the ingredients
used.
Use whole milk for best results,
removing it from the fridge immedi-
ately before pouring it into the jug
(2).
After a first heating cycle, wait for
the appliance to cool before starting
a second one.
Do not use the appliance without
liquids. Starting the appliance with-
out liquids could damage the jug.
Always fill up to the MIN level and
not beyond the MAX level, both
indicated inside the jug.
The appliance is in error status when
the LED on the knob flashes and
three acoustic signals are repeated
twice.
The appliance displays an error
status if the jug or whisk is not
installed, the jug is removed during
preparation or the cycle is started
with an empty jug.
In the first two cases the cycle fails to
start, while in the last two the cycle
starts but stops after a few seconds.
• Insert the plug into the power outlet.
• The LED (8) flashes, after about 120 sec-
onds of inactivity the appliance positions
itself in stand-by and the LED turns off.
Heat or froth the milk
• Remove the lid (4) and pour cold milk into
the jug (2), referring to the level indications
printed inside the jug itself.
• Refit the lid (4).
• Select the desired program by turning the
knob (7) in correspondence with the red
mark positioned on the knob ring.
The appliance passes from standby
to the work phase.
• Press the START/STOP button (6) to start the
cycle, the LED (8) lights up with a fixed light.
• An acoustic signal and the turning off of the
LED (8) indicate the end of the cycle.
• It is possible to stop the cycle before the time
set by pressing the START/STOP button (6).
• Remove the lid (4) holding it by the side
flaps.
• Remove the jug (2) and pour the milk with
the aid of a spoon.
It is best to add any sugar or sweet-
ening syrups (e.g. honey, agave or
maple juice, etc.) at the end of the
cycle.
Preparing hot chocolate
• Remove the lid (4) and pour the chocolate
ingredients into the jug (2), referring to the
level instructions printed inside the jug and
the recommendations provided by the Smeg
recipe.
• Select the relative program and proceed in
the same way as for milk.
Powder ingredients can be added
during the work phase by removing
the measuring cap (5).
Add the ingredients gradually and in
small amounts a few moments after
the start of the cycle so that the milk
Use
Loading ...
Loading ...
Loading ...