Loading ...
Loading ...
Loading ...
SmegConnect
24
14.Wait for the beep.
The Access Point credentials change
procedure is completed.
The device is connected to the Internet
again and can be remotely controlled.
2.7 Connection information
The following information about the
connection can be found in the product
pages under the Settings menu on the App:
• Appliance registration date
•Network name
• Strength of the Wi-Fi signal
• Mac address of the connectivity card
• Firmware version of the connectivity
card
• IPv4 and IPv6 network addresses
• SW Compliance ID (identification of
compliance with the essential
requirements of the RED directive).
The device supports network
names (SSID) up to 24 digits
(including spaces) and WPA2
security settings (not WEP or WPA)
If Connection Failed is
displayed during registration, it
means that some passages of the
procedure did not work properly
or were interrupted.
To remove press the key
Alarm (wine cellars with
single compartment) or the key for
upper compartment display
(wine cellars with double
compartment).
Loading ...
Loading ...