Loading ...
Loading ...
Loading ...
6
NOTICE: This heater is
intended for use as supplemental
heat. Use this heater along with
your primary heating system.
Do not install this heater as
your primary heat source. If you
have a central heating system,
you may run system’s circulat-
ing blower while using heater.
This will help circulate the heat
throughout the house. In the
event of a power outage, you can
use this heater as your primary
heat source.
WARNING: A qualied
service person must install
heater. Follow all local codes.
INSTALLATION NEEDS
Before installing heater, make sure
you have the items listed below.
piping (check local codes)
sealant (resistant to natural
gas)
equipment shutoff valve*
ground joint union
test gauge connection*
sediment trap
tee joint
pipe wrench
*A CSA/AGA design-certied equip-
ment shutoff valve with 1/8” NPT
tap is an acceptable alternative to
test gauge connection. Purchase the
optional CSA/AGA design certied
equipment shutoff valve from your
dealer.
CAUTION: If you install the
heater in a home garage
heater pilot and burner must
be at least 18 inches above
oor.
locate heater where moving
vehicle will not hit it.
Figure 3 -Ventilation Air from Outdoors
CAUTION: This heater creates
warm air currents. These currents
move heat to wall surfaces
next to heater. Installing heater
next to vinyl or cloth wall cover-
ings or operating heater where
impurities (such as tobacco smoke,
aromatic candles, cleaning uids,
oil or kerosene lamps, etc.) in the
air exist may discolor walls.
Use only natural gas. If your
gas supply is not natural, do
not install heater. Call dealer
where you bought heater for
proper type heater.
CHECK GAS TYPE
This heater is designed to be
mounted on a wall.
For convenience and efficiency,
install heater
where there is easy access for
operation, inspection, and
service.
in coldest part of room.
LOCATING HEATER
WARNING: Never install
the heater
in a bathroom
in a recreational vehicle.
where curtains, furniture,
clothing, or other ammable
objects are less than 36 inches
from the front, top, or sides
of the heater.
as a replace insert.
in high trafc areas.
in windy or drafty areas.
INSTALLATION
Ventilation Air From Outdoors
Provide extra fresh air by using venti-
lation grills or ducts: You must pro -
vide two p er ma ne nt o pe ni ngs: o ne
within 12” of the ceiling and one within
12” of the oor.
Connect these items directly to the
outdoors or spaces open to the outdoors.
These spaces include attics and crawl
spaces. Follow the National Fuel Gas
Code NFPA 54/ANS Z223.1, Section 5.3.
Air for Combustion and Ventilation for
required size of ventilation grills or ducts.
IMPORTANT: Do not provide openings
for inlet or outlet air into attic if attic
has a thermostat-controlled power vent.
Heated air entering the attic will activate
the power vent.
When the heater is installed in
Bathrooms,do not use ammable
products such as aerosol hair foot
spary or any product that contains
ammable vapors and keep towels
away from heater.
Loading ...
Loading ...
Loading ...