Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS (continued)
Supply
Ground
Wire
__________________________
Part Two
__________________________
Install Heater Assembly
STEP 1
Place heater assembly inside wall can and secure
with two screws (provided).
Install Grill
STEP 3
Secure grill with the screws provided. Slide thermo-
stat knob onto shaft. Turn power on at the electrical
panel board.
Important: Before turning on power, be sure the
thermostat knob is turned counter clockwise to the
lowest setting, and the switch is in the “FAN” or
“AUTO” position.
After you have followed all instructions in PART ONE, for either new construction or an existing wall, you are
ready to install the heater assembly.
How do I insert the heater assembly into the wall can?
STEP 2
Route Supply Wires
Route supply wire from circuit breaker to top of wall can. Remove
knockout and attach the supply wire with a strain relief connector,
leaving 6 inches of wire lead for later use. Connect supply ground
wire to grounding screw in wall can (See Figure 3).
Proceed to PART TWO.
STEP 3
Mount Wall Can
Insert wall can into opening. Keeping front of wall can ush with
wall, secure to wall stud with screws through the four larger (3/16
inch) holes. Connect supply ground wire to grounding screw in
wall can (See Figure 3).
Proceed to PART TWO.
__________________________
Part One
__________________________
How do I install for new construction? How do I install in an existing wall?
Figure 5
Wire Connections
STEP 2
Connect the 2 heater wires to the 2 supply wires us-
ing electrical insulated wire connectors (see Figure
5). Push wires into wiring junction box.
Page 4
Loading ...
Loading ...
Loading ...