Loading ...
Loading ...
Loading ...
31-2000734 Rev. 0 11
Installation
1
INSTALL HOOD SUPPORT
IMPORTANT: Framing must be capable of supporting
100 lbs for 36” models and 150 lbs for 48” models.
• Locate a minimum of 2 vertical studs for the
installation bar by tapping drywall with a hammer or
use a stud finder.
• Level the installation bar and center left to right
above the marked line. Hold bar against the wall.
• Drill 1/8” pilot holes at the 2 vertical stud locations
through holes in the installation bracket. Secure the
installation bar with supplied screws (A) as shown
above.
Drill Bottom Mounting Hole Locations:
• Hang hood on installation bar or use the table below
to mark the screw hole locations. NOTE: If installing
to the soffit, push hood flush to the soffit before
marking screw hole locations.
• Remove the hood and drill 5/16” clearance holes at
marked locations “A” and “B”.
2
INSTALL DAMPER
IMPORTANT: Remove shipping tape from damper
and check that damper moves freely.
Install Top Damper:
• The motor mounting plate comes pre-installed in the
hood for top venting.
• Install the top damper to the hood body as shown in
Figure A using screws (B) from top of hood.
Install Back Damper:
• In case of back venting through the wall, back
damper accessory UXBDA812 must be purchased
separately.
• Uninstall the motor mounting plate from top venting
position. Save the screws.
• Remove the square knockout panel on hood body for
back venting.
• Remove the two screw knockout holes on the motor
mounting plate as shown in Figure C.
• Install the motor mounting plate to back panel so that
the arrow on plate is pointing upwards and on the
right side.
• Push plate in until metal clips
engage. Fasten plate through
screw knockouts shown in
Figure C using the two screws
saved.
• Install the back damper to the
hood body as shown in Figure
B using screws provided with
the accessory.
• Install the metal plate provided with the accessory to
cover the opening for top damper.
Installation Bar
Centerline of
Installation Space
16-3/4”
24” minimum over electric range
or cooktop, or 30” minimum over
gas range or cooktop, and 36”
recommended maximum.
Figure A
Figure B
1
INSTALL HOOD SUPPORT (Cont.)
• Install wall anchors (C) by tapping the anchors with
a hammer to seat the teeth of the flanges into the
wall. This keeps anchor from rotating.
• Drive the anchor screws until the barrels crimp
against the inside of the wall.
• Remove the screws from the wall anchors before
installing the hood.
B
A
Bottom of Hood
Centerline of
Installation Space
“A” “B”
36” Model 11-7/8”
4”
48” Model 17-3/4”
TOP
Figure C (Panel will look
different for single motor)
Screw Knockouts
Loading ...
Loading ...
Loading ...