Loading ...
Loading ...
Loading ...
Basic operation en
39
4. Push in the detergent drawer.
Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press Start/Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
1. Press Start/Reload.
2. Press Finish in repeatedly until the
display indicates the desired
"Ready in" time.
3. Press Start/Reload.
Soaking laundry
You can soak the laundry before
washing in the appliance by pausing
the programme.
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press Start/Re-
load.
3. To resume the programme, after
the desired soaking time, press
Start/Reload.
Adding laundry
Note:Please read the information in
the Safety →Page4 and Preventing
material damage →Page11 sections
to ensure that you use the appliance
safely.
1. Press Start/Reload.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
→"Display", Page26
2. Add or remove laundry.
3. Close the door.
4. Press Start/Reload.
Cancelling the programme
Once the programme has started,
you can cancel it at any time.
Note:Please read the information in
the Safety →Page4 and Preventing
material damage →Page11 sections
to ensure that you use the appliance
safely.
1. Press Start/Reload.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high: Start
the Spin or Drain programme.
3. Remove the laundry.
Resuming the programme when
the programme status is Rinse
Hold
1. Set the Spin or Drain programme.
2. Press Start/Reload.
Loading ...
Loading ...
Loading ...