IP2M-841EW Crest Audio

User Manual - Page 63

For IP2M-841EW.

PDF File Manual, 66 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
63
click the Video Detection menu item. On this screen, ensure that the Enable checkbox is checked, then setup the
schedule, anti-dither setting, detection area, and then check the boxes of all the actions you want the camera to
perform once motion is detected. For more information on Motion Detection, please see section 5.2.3.1 of this
user manual.
20. The system does not detect an SD Card.
Below are a few possible reasons why this may be occurring:
The SD card is broken.
The SD card slot is malfunctioning.
The SD card has not been formatted properly.
Glossary of Terms
Abnormality Any malfunction in terms of storage of data to the SD card.
Alarm Delay The gap in time between alarm activation and Relay alarm activation.
Alternate Gateway The node on the computer network that the network software uses when an IP address
does not match any other routes in the routing table, and when the default gateway is not available.
Anti-Dither This time value controls how long the alarm signal lasts. The values in this field can range from 5
to 600 seconds. Based on motion detection, a buzzer can go off, a tour can begin, a snapshot can be taken, or
the camera can begin recording.
DDNS This stands for Dynamic Domain Name System. DDNS is a method of automatically updating a name
server in the Domain Name System (DNS), often in real time, with the active DNS configuration of its
configured hostnames, addresses or other information.
Default Gateway The node on the computer network that the network software uses when an IP address
does not match any other routes in the routing table.
DHCP Dynamic Host Configuration Protocol is a network protocol that enables a server to automatically
assign an IP address to a computer from a defined range of numbers (i.e., a scope) configured for a given
network.
Fluency Fluency described the lack of stuttering or excessive delay in a video stream. Fluency usually comes
at the expense of video quality when a network is constrained.
IP Address Internet Protocol Address is a unique numerical label assigned to each device connected to a
computer network. The IP address allows communication between different devices on a network.
Main Stream Main Stream is the main streaming protocol for the camera. Main stream uses more
bandwidth and attempts to keep quality and fluency high.
NO/NC Normally Open and Normally Closed are options for sensor type. These settings allow for different
exposure types when capturing video and still images.
NTP Network Time Protocol is a networking protocol for clock synchronization between computer systems
over packet-switched, variable-latency data networks.
P2P Peer-to-Peer is a decentralized communications model in which each party has the same capabilities
and either party can initiate a communication session.
PPPoE Point to Point Protocol over Ethernet is a network protocol for encapsulating Point to Point Protocol
data packets inside Ethernet frames.
PTZ Pan Tilt Zoom is a feature that allows a camera to remotely change its position.
QR Code Quick Response code is a type of digital barcode that enables devices to share complex data
strings quickly.
Loading ...
Loading ...
Loading ...