Documents: Go to download!
- Owner's manual - (English)
User manual Washing Machine Samsung WA85R6350BW/SA
Contents
- Safety information
- What you need to know about the safety instructions
- Important safety symbols 3 n
- Important safety precautions
- Installation
- What’s included
- Installation requirements
- Step-by-step installation
- Before you start
- Detergent guidelines
- Smart Check
- Laundry guidelines
- Operations
- Control panel
- Simple steps to start
- Auto cycles
- Special features
- Maintenance
- Cleaning
- Troubleshooting
- Checkpoints
- Information codes
- Specifications
- Specification sheet
Cleaning
Exterior: Clean the control panel with a soft, damp cloth. Do not use abrasive powders or cleaning pads. Do not spray cleaners directly on the panels.
Tub Clean: Regularly run this cycle to clean the tub and to remove bacteria from it.
- Makes sure the tub is completely empty.
- Press POWER to turn on the washing machine.
- Press Cycle 3 to select TUB CLEAN. You can also use Delay End with Tub Clean.
- Press and hold START/PAUSE
Tub Clean reminder
- The indicator reminds you of cleaning the tub when necessary. If you happen to see the indicator blinking after washing is complete, remove the laundry and run the TUB CLEAN cycle.
- You can ignore this reminder and continue to run cycles normally because this is not a system failure. However, the reminder remains active for 6 consecutive cycles immediately after each cycle is complete.
- The reminder is activated once every 1-3 months, depending on the cycle count.
- To keep the tub clean, it is recommended to run Tub Clean on a regular basis.
Built-in sink
- Open the door, and use a cloth or sponge to clean the Built-in sink.
- Press Water Jet to supply water to the board. Use this water to rinse the board.
Troubleshooting
Does not turn on.
- Make sure you use rated power for the product.
- Make sure the power cord is completely plugged in.
- Check the fuse or reset the circuit breaker
After a cycle, detergent remains in the automatic dispenser.
- Make sure the washing machine is running with sufficient water pressure.
- Make sure the detergent drawer is properly inserted.
- Remove and clean the detergent drawer, and then try again.
The Tub Clean alarm does not turn off.
- When the machine is diagnosed to be cleaned, the indicator blinks for an hour. This recurs 6 consecutive times until you run the TUB CLEAN cycle. This is normal, and not a system failure. To keep the tub clean, it is recommended to run the cycle once every 1-3 months.
See other models: QA65QN700AWXXY QA75QN700AWXXY RS65T5685B4/SA GY-Z5 SM-R220NZRAXAR