Refrigerator
Operating Instructions
P221TMW
• Please carefully read the operation instructions before powering on, and keep them safe.
• Product specifications subject to change without notice.
Children should be supervised to ensure they do not play with the appliance.
1
Do not use electrical appliances inside the food storage
compartments of the appliance, unless they are of the type
recommended by the manufacturer.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
WARNING!:Do not locate multiple portable socket-outlet or portable
power supplies at the rear of the appliance.
2
3
As a responsible supplier, we care about the environment.As such, we
ask that you follow the correct disposal procedures for your product
and packaging.This will help ensure that your product
4
is recycled in a manner that protect the environment and your health.
You must dispose of your product and packaging according to local laws and
regulations. Because this product contains electronic components and
possibly batteries, this product and its accessories must be disposed
separately from your household waste when the product reaches end of life.
Contact your local authority to learn about disposal and recycling. The
product should be taken to your local collection point for recycling. Please
note that regulations may change, so always consult with your local authorities
at time of disposal.
5
The actual may slightly differ.
Control Knob
Control Knob
Freezer
Compartment
Chill
Compartment
6
LevellingFeet
Shelves
Shelves
Door Reversal
7
Before reversing the door, please ensure you have following tools:Flat Screwdriver, Phillips Head
Screwdriver (Star type), Spanner and the components in the poly bag:
1. Close the upper door and take out the screw from the top hinge covers using a Phillips head screwdriver.
Take off the hinge cover, then unscrew the top hinge and take off the upper door.
2. Unscrew the middle hinge using a Phillips head screwdriver, then remove the lower door.
3. Laying down the refrigerator, take out the adjusting feet as shown below, then unscrew the lower hinge
using a Phillips head screwdriver. (Please note- once the fridge is upright, please wait about 2 hours
before turning on the fridge, and do not leave the fridge laying down longer than necessary).
4
5
Door Reversal
8
the proper position.
6. Rotate the middle hinge 180° , inset the middle hinge pin to the upper hole of the lower door on
the left side, and re-insert and tighten the screws ans shown below.
Door Reversal
9
.
7. Unscrew the right middle stopper with the metal block from the bottom of the upper door. Then,
install the left middle stopper and metal block on the left side of the bottom upper door.
9. Take the left hinge cover from the accessory bag and attach it to the top hinge. Then install
the hole cover on the right side.
Installation
135
980mm
910mm
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
Levelling the unit
10
#
8
6
19
9
1&
&
:0 6: 6
:" 6: 6
:"
6
: .
6
:" 6:+ 6
&!!
$&!
!5
00#!!
7
,
#
2
;!<
&&
#$!
!<
&
&6(
11
Freezer compartment Temperature Setting
Plug on your appliance. The internal temperature is controlled by a sensor. There are 3 settings:
COLD, COLDER and COLDEST.
The appliance may not operate at the correct temperature if it is in a particularly hot or if you open
the door often.
Fridge
compartment Temperature Setting
P
l
ug
on
your
appliance.
T
h
e
internal temperature is controlled by a sensor. There are 4 settings:
O
F
F
, C
O
L
D, COLDER and COLDEST. COLD is warmest setting and COLDEST is coldest setting,
OFF is off.
The appliance may not operate at the correct temperature if it is in a particularly hot or if you open
the door often.
Neither fridge or freezer compartment works when the setting is OFF.
12
'
"#
"##*+##+#7+
+;#5,+*#5#"#5
!
%#&
6
",;+*#+"##!
65
'"#
2#,"#"
"!
##,#,!
2#8#,##"!
2#"#<"##,!
."
=#" E"###
###"#"!
%#&)#;"*8#+#,"##
;#+####%"(*#,
>7575# 7!
2#+"
6 *,*,#+#"
*"#;,#!
.5;,7*5#!)#*7"+7
"!
2#+#">+#
###;,!
?;,#;
2"7";*#
shelves,#"#!27#
+<"5#shelf#
#+*#>!
"#shelves
13
@"
2,#,#*5#<
7##5
+
>5,5#A
,#####,
A
#>5;"#,55!
&*5,!
68#",5#!
@#"
2,#,<
6+;">#"
6;+#*5#";
@"
-#<
?75<+5#,"#"#;,;#;",+!
'5*
#+55+5#!
7*#*!!!<##,;5,5#!
';",<##,#"#5#+;!
,#<##,"#+
5#,"8#,!
?7,<###;#,#,#!
**"*7*,7#"!
2#57##"*##<
#8>5+##,#!#+#"A
#"7#!3#,#,"#A
5>5*#
#"#5*A
,,557,
,>5#+5#>5>A
+#5#7##7""#A
+#*#+##5*#;"
#A
,"#5A#"A
+*5;#*,5
#7,,A
;,#+#"#;7,5;#
*,5#7,,A
;,#+#"#;7,57,#
"!
@#
@"
14
Setting the humidity in the Crisper:
Low humidity: move the regulator to the left
Hight humidity: move the regulator to the right
"
'#5"#*"*#,"5!
&
2#5,#""!6"
#7B"+##;#"#*+#
#,7!3;#+#!?
*"#7B@;#"
!2#,5,,7;!
%#&/#";7*!"!#
"*,5*#!
6+#,#!
65,;
0;##!.#*+;!
.+##;#
"#*+##,7
!
##+##7++!"+
+##+,5!
;5#"5,7;!
15
or
There will be some sound/noise during normal operation (compressor or refrigerant circulation).
does
16
CKTCL-
TCL Electronics Australia Pty Ltd.
ABN 83 111 032 896
Telephone: 1300 738 149
www.tcl.com/au
