Loading ...
Loading ...
Loading ...
20
21
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE REMEDY
The water tank is empty or positioned
incorrectly.
Fill the tank with water and/or insert it
correctly, pushing it as far as it will go.
The grinding is too ne and the coee is
delivered too slowly.
The machine cannot make coee as there
is air in the hydraulic circuit.
Turn the grinding adjustment knob one
click clockwise towards “7”.
button (C5) and deliver water from the
spout for a few seconds.
The hot water spout is not inserted or is
inserted incorrectly.
Insert the hot water spout as far as it will
go.
The grounds container (A4) is too full or
more than 3 days have passed since you
last made coee (this guarantees correct
hygiene of the machine).
Empty the grounds container and clean,
then replace.
Important: when removing the drip tray,
even if it is not completely full.
If this is not done, when you make the
next coees, the grounds container may
ll up more than expected and clog the
machine.
After cleaning, the grounds container has
not been replaced.
grounds container.
The milk container is not inserted. Insert the milk container as far as it will
go.
With the pre-ground function selected,
pre-ground coee has not been poured
into the funnel.
The funnel (A17) is blocked.
Extract the appliance and place pre-
ground coee in the funnel.
Empty the funnel with the help of a knife,
as described in the section “Cleaning the
pre-ground coee funnel”.
DESCALE! The machine must be descaled. The descaling procedure described in the
“Descaling” section needs to be perfor-
med as soon as possible.
Too much coee has been used Select a milder taste or reduce the quan-
tity of pre-ground coee, then make the
coee again
The coee beans have run out. Fill beans container
The infuser has not been replaced after
cleaning.
Insert the infuser as described in the sec-
tion “Cleaning the infuser”.
The service door is open Close the service door.
The inside of the appliance is very dirty. Clean the inside of the appliance thorou-
ghly, as described in the section “Cleaning
and maintenance”.
If the message is still displayed after clea-
ning, contact a customer services.
Loading ...
Loading ...
Loading ...