Loading ...
Loading ...
Loading ...
10
4. Using a T20
®
TORX
®
screwdriver, remove the ve or six
screws holding the rear heat lamp panel, two in the sides
and three or four in the back. Set the heat lamp panel and
screws aside.
5. Mount range hood. See the “Install Range Hood” section.
Install Range Hood Internal Blower Motor
1. Using two or more people, install the range hood blower
motor assembly inside the range hood canopy with the
wiring connection to the left for the single motor system and
to the front or top for the dual motor system.
Single Blower Motor Assembly
Dual Blower Motor Assembly
2. Run the power supply wires and connector from the range
hood through the hole in the right end of the motor mounting
plate.
3. With the blower motor assembly mounting plate parallel
to the bottom of the range hood, slide it up into the cavity
above the range hood canopy.
4. Align mounting holes in motor mounting plate with motor
mounting clip nuts, and install 6 x 16 mm screws and
6.4mm lock washers (quantity two for single motor; quantity
ve for dual motor). After all the screws have been installed,
tighten the screws.
A
BA
A. Screws: panel mounting (five) for 36" (91.4 cm)
models, (six) for 48" (121.9 cm) models
B. Panel: heat lamp
WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
A
A. Wiring connection
A
A. Wiring connection
A. Motor mounting plate hole
B. Power supply wires and connector
A
B
A
B
C
D
A. Screw with lock washer
B. Mounting hole in motor mounting plate
C. Clip nut (6 mm)
D. Motor mounting plate
Loading ...
Loading ...
Loading ...