Loading ...
Loading ...
Loading ...
Page 7
INSTALLATION GUIDE
When you open the box, you should have received:
Portable dehumidier
User Guide
Castors (4)
Continuous Drain Kit
To Install Castors:
1. Remove castors from the water collection bucket.
For the 70 pint model (BDT70WT), the four castors can be taken out from the
side of the bucket directly (see g 1).
For the 30 pint (BDT30WTA) and 50 pint (BDT50WT) models, check if the
castors are under the lid of the bucket. If so, remove lid to access castors, then
replace lid before operation. (see g. 2)
2. Tilt the dehumidier no more than
45 degrees and push to insert the castors
into the base of the unit. Make sure the ring
around the castor is ush against the bottom
of the dehumidier. (see g. 3).
SET UP & USE
Bucket
lid
Hole
Buckle
lid
Float
1.Using two hands gently remove lid
from the top of the bucket.
2.Remove casters
from bucket
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
Bucket
lid
Hole
Buckle
lid
Float
1.Using two hands gently remove lid
from the top of the bucket.
2.Remove casters
from bucket
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
Fig. 1
Bucket
lid
Hole
Buckle
lid
Float
1.Using two hands gently remove lid
from the top of the bucket.
2.Remove casters
from bucket
3.Re-install the lid and be
sure that it is securely
clipped into the bucket
Important Note: Verify the plastic float
system on the top of the bucket is still
securely installed and swinging properly
before placing bucket back in the
dehumidifier
Fig. 2
Fig. 3
Loading ...
Loading ...
Loading ...