Loading ...
Loading ...
Loading ...
10
Control
CFM
REDUCTION
SYSTEM
1 2 3 4 5 6
1. Button ON/OFF motor (stand by)
2. Button for low speed (suction power) selection
When flashing, it indicates that you must wash the grease filter.
3. Button for medium speed (suction power) selection
4. Button for high speed (suction power) selection
5. Button for intensive speed (suction power) selection
It lasts 5 minutes then it returns to medium speed
(suction power).
6. Button ON/OFF lighting
Press briefly to switch on or o the lighting of the hood.
Press and hold to adjust the intensity of the light.
Indicators of filter saturation:
At regular time intervals, the hood indicates the need of
performing filter maintenance.
Button on with steady light:
Perform grease filter maintenance.
Button flashing:
Perform activated charcoal filter maintenance.
Note: Filter saturation signal is visible within the first minute
after switching off the hood; within this time, the reset of
saturation indicators must be performed.
Reset of filter saturation indicators:
Press and hold the button
Activation of saturation indicator activated charcoal filter:
Note: This operation must be performed with the hood off.
This indicator is normally desactivated; press and hold the
button to activate the function: the button lights up with
steady light.
To desactivate the function, press and hold the button ,
the button lights up flashing.
Before operating your hood:
Some regions and provinces of the US and Canada restrict
the exhausting power of range hoods to performances below
certain values. These values are underlined in the local code
for your area.
Please check your local code to find out if you will need to
restrict the power of your hood.
If your local code restricts the performance values of range
hoods, please execute the following button-pressing sequence:
Low performance:
This function allows to lock the user interface to control the
third and four speeds.
This function can be enabled only with motor OFF.
1 5
• Press the ON/OFF (1) and Intensive speed (5) buttons
together for 3 seconds.
• You will hear a beep and all control lights will go on for 3
seconds.
The 3rd and 4th speeds will be Disabled.
Mainteinance
Cleaning
Do not spray cleaners directly to the control while cleaning the
Hood. The cooker hood should be cleaned regularly (at least
with the same frequency with which you carry out maintenance
of the fat filters) internally and externally. Clean using the
cloth dampened with neutral liquid detergent. Do not use
abrasive products.
DO NOT USE ALCOHOL!
I WARNING:
Failure to carry out the basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate maintenance
or failure to observe the above safety recommendations.
Grease Filter
Traps cooking grease particles.
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be
set to a low temperature and a short cycle. When washed in
a dishwasher, the grease filter may discolour slightly, but this
does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle.
A
Replacing a LED Lamp
The LED lights are replaceable by a service technician only.
See “Assistance and Service” section for service contact
information.
Charcoal Filter
If the model is not vented to the outside, the air will be
recirculated through disposable charcoal filters that help
remove smoke and odors.
The charcoal filters cannot be cleaned.
They must be replaced.
The charcoal filters are clipped inside of each metal grease
filter (mounting instructions included with charcoal filters kit).
The charcoal filters should be replaced every 4-6 months
(depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filters in an automatic
dishwasher.
NOTE: Charcoal filters are not included with the hood.
They must be ordered from your supplier.
Order the needed kit specifying your hood model and width
size.
Charcoal filter placement (Recirculating accessories)
Fit the charcoal filter mattress on the upper side of each
grease filter.
Use provided springs to fix it in place.
Loading ...
Loading ...
Loading ...