Loading ...
Loading ...
Loading ...
5
– Unattended: Do not leave the appliance unattended
when in use.
– Attachments: The use of attachments not
recommended or sold by the manufacturer may
cause fire, electric shock or injury.
– Startup settings: Set the unit to maximum cooling
and high speed ventilation for the initial startup,
then adjust the unit down to a more comfortable
setting as required.
– Airflow: Do not direct the airflow onto plants or
animals, as long and direct exposure to cold air from
the air conditioner could adversely aect them.
– Cold air exposure: Never remain directly exposed
to the flow of cold air for a long time, as direct
and prolonged exposure to cold air from the air
conditioner could be dangerous for your health. Take
particular care in rooms where there are children,
old, or sick people.
– Moving the appliance: When moving the air
conditioner, always turn o and disconnect the
power supply, and move it slowly.
– Never place any objects containing liquid, such as
flower vases or drinks, on top of the product.
– Never handle the product with wet hands or
while barefoot.
– Switch o and unplug the product when it is not in use.
– WARNING! If the product should tip over,
immediately turn it o and unplug it.
CLEANING AND MAINTENANCE
– Disconnect: Make sure the appliance is disconnected
from the power supply when it will not be used for a
long time and before carrying out any cleaning
or maintenance.
– Air filter: Keep the air filter clean. Do not use the
unit without the air filters fitted. Using it without
air filters could cause an excessive accumulation of
dust or waste on the inner parts of the device with
possible subsequent failures.
– Service and repair: The air conditioner has no
user-serviceable parts contained inside. Do not
attempt to disassemble, modify or conduct repairs
on this unit. It has been built in accordance with
relevant safety and performance standards. An
electrical specialist must carry out all repairs.
Contact our after sales support line for advice on
service.
– Cooling eciency: To help cooling eciency, keep
blinds and curtains closed during the sunniest part
of the day. Close o any fireplace damper, floor and/
or wall register so cool air does not escape through
the chimney or duct work.
INSTALLATION
– Proper installation: Install the appliance according to
the instructions in this manual and national wiring
regulations. Improper installation may result in the
risk of fire, electric shock and/or injury. We assume
no responsibility for any eventual damages caused
by improper installation or faulty use.
– Upright position: Place the unit on a flat surface to
reduce the risk of it tipping over. Do not tilt the unit,
always keep it upright. If the unit has not been kept
upright (such as during storage), wait for at least
24 hours before operation.
– Obstructions: Do not locate the air conditioner where
furniture or other objects can obstruct the airflow.
– Do not cover: Do not cover the air conditioner or
obstruct any air inlet or outlet grilles. Obstructing
these openings causes a fire hazard, reduces the
operating eciency and may lead to malfunction or
damage.
– Chemicals: Do not install the air conditioner in
environments where the air could contain gas, oil or
sulphur. Do not let chemical substances come into
contact with the unit. Do not use the unit in the
presence of flammable substances or vapour such as
alcohol, insecticides, petrol etc.
– Heat: Do not install the air conditioner near sources
of heat, or exposed to direct sunlight.
– Clearances: Always keep a clearance of at least
30cm from walls, furniture and curtains.
This symbol shows that this appliance uses a flammable refrigerant
(R290). If the refrigerant is leaked and exposed to an external ignition
source, there is a risk of fire.
NOTE ABOUT FLUORINATED GAS NOT APPLICABLE
TO UNITS USING R290 REFRIGERANT
– Fluorinated greenhouse gases are contained
in hermetically sealed equipment. For specific
information on the type, the amount and the CO2
equivalent in tonnes of the fluorinated greenhouse
gas(on some models), please refer to the relevant
label on the unit itself.
– Installation, service, maintenance and repair of this
unit must be performed by a certified technician.
– Product uninstallation and recycling must be
performed by a certified technician.
Loading ...
Loading ...
Loading ...