Loading ...
Loading ...
Loading ...
10
EXHAUST VERSION
Connect the ange Y to the exhaust opening
with a connecting tube Fig.5 (not necessary
for recirculating version).
Thread the upper connector E to the inside
of the lower connector F; hang the two
connectors inserting them vertically on the
cooker hood, unthread the upper connec-
tor E towards the top, locking it in with the
appropriate screws in the drill holes G of the
bracket Z (g. 7) previously axed to the
wall via the drill holes C (g. 1).
RE-CIRCULATING VERSION
In order to transform your cooker hood
from the exhaust version to the re-circu-
lating version, ask your local retailer for
active carbon lters and then carry out the
assembly instructions for the lter version.
The active carbon lters are not included in
the hood, but must be purchased as a kit se-
parately. The lters must be applied to the
suction unit located inside the hood (g. 6).
The air is replaced in the environment via
the eyelets impressed on the connector A.
CONTROL PANEL
A B C D E
A- Fan-off
B- First speed (minimum)
C- Second speed (medium)
D- Third speed (maximum)
E- Light ON/OFF
MAINTENANCE
Caution!
Before any cleaning or maintenance
disconnect the hood from the mains by
removing the plug or disconnecting the main
switch of the dwelling.
Cleaning
The cooker hood should be cleaned re-
gularly (at least with the same frequency
with which you carry out maintenance of
the grease lters) internally and externally.
Clean using the cloth dampened with neu-
tral liquid detergent, mild, non corrosive.
Do not use abrasive products. DO NOT USE
ALCOHOL!
WARNING: Failure to carry out the basic
cleaning recommendations of the cooker
hood and replacement of the lters may
cause re risks. Therefore, we recommend
observing these instructions.
The manufacturer declines all responsibi-
lity for any damage to the motor or
any re damage linked to inappropriate
maintenance or failure to observe the
above safety recommendations.
The manufacturer declines all responsi-
bility of damage or malfunctions due to
appliance not being installed according
to instructions.
Grease lter
The grease lter captures grease and oil
particles. Filters must be cleaned once a
month, using non aggressive detergents,
either by hand or in the dishwasher, which
must be set to a low temperature and a
short cycle. When washed in a dishwasher,
the grease lter may discolour slightly, but
this does not affect its ltering capacity.
Charcoal lter (recirculating version only)
It absorbs unpleasant odours caused by
cooking. The saturation of the charcoal lter
occurs after prolonged use or frequent use,
depending on the type of cooking and the
frequency of cleaning of the grease lter.
In any case it is necessary to replace the
cartridge at least every four months. The
charcoal lter may NOT be washed or rege-
nerated.
Loading ...
Loading ...
Loading ...