Loading ...
Loading ...
Loading ...
9
2
3
1
2
1
2
3
1
2
1
2
3
1
2
1
Washing your Laser Slim Fluffy™ brush bar
Replace your brush barRemove your brush bar Wash and dry your brush bar
Don’t put any part of your
machine in a dishwasher
or use detergents, polishes
or air fresheners.
Press the cleaner head release
button on the end of the wand.
Place the cleaner head upside
down.
Push the end cap up fully and
pull the brush bar out of the
cleaner head.
Hold your brush bar under
running water and gently rub
to remove any lint or dirt.
Stand your brush bar upright as
shown. Leave to dry completely
for at least 24 hours.
Before replacing, check that
your brush bar is completely dry.
Reattach the end cap to your
brush bar.
Slide your brush bar into the
cleaner head.
Push the end cap back down
to the closed position.
To maintain optimum
performance, keep your laser
lens clean. Only clean the lens
when the cleaner head is not
attached to your machine.
Use a soft, dry, lint-free cloth
to wipe the lens.
Cleaning your laser lens
Your Laser Slim Fluffy™ cleaner head has a washable brush
bar. To maintain optimum performance, check and wash
your brush bar regularly.
Make sure your machine is disconnected from the charger
and take care not to touch the trigger.
2
1 3 4
The end cap should
be attached to the
cleaner head at an
angle less than 90°,
any angle greater
than this will not allow
the end cap to close.
The brush bar has an
open end and a closed
end. Stand upright,
with the closed end
facing upwards, to dry.
The end cap is located
at the side of the cleaner
head. Push this upwards
to unlock the brush bar.
Don't wash the end cap.
Loading ...
Loading ...
Loading ...