Loading ...
Loading ...
Loading ...
26
INSTALLER SETTING
ENGLISH
INSTALLER SETTING
27
ENGLISH
Test run mode (Code 1)
After installing the product, you must run a Test run mode.
For details related to this operation, refer to the product manual.
00 : Normal operation (Default)
01 : Initiate cooling test mode
02 : Initiate heating test mode
During the test run, pressing the below button will exit the test run.
- On/Off, temp, fan speed, oper mode button.
Address setting (Code 2)
Sets the central control address of the indoor unit during the central controller connection.
XX : central control address number (00~FF)
E.S.P. function (Code 3)
Sets the wind amount value corresponding to each wind amount for easy installation.
[Select fan speed] E.S.P value : 000~255
01 : Slow
02 : Low
03 : Middle
04 : High
05 : Power
❈
Press button to select fan speed or
E.S.P value.
Function code
E.S.P value
Fan speed
NOTE
!
• Please be careful when adjusting ESP values.
• It does not work to setup ESP value for slow/power step for some products.
• ESP value range is dependent on product.
Temperature sensor setting (Code 4)
Determines if you will use the indoor unit mounted sensor or the remote controller sensor.
<Thermistor table>
Temperature sensor selection Function
01 Thermostat Operate according to thermostat temperature sensor
02 Indoor unit Operate according to indoor unit temperature sensor
03 2TH
Cooling
Operate according to higher temperature by comparing in-
door unit's and thermostat’s temperature. (There are
products that operate at a lower temperature.)
Heating
Operate according to lower temperature by comparing in-
door unit's and thermostat's temperature.
Ceiling height level Description
01 Low Decrease the indoor airflow rate 1 step from standard level
02 Standard Set the indoor airflow rate as standard level
03 High Increase indoor airflow rate 1 step from standard level
04 Very High Increase indoor airflow rate 2 steps from standard level
Ceiling height (Code 5)
Controls the fan speed stage according to the ceiling height in the ceiling type product.
<Ceiling height selection table>
❈
The function of 2TH has different operation characteristics according to the product.
❈
Ceiling height setting is only available for some products.
❈
Ceiling height of ‘Very high’ function may not exist depending on the indoor unit.
❈
Refer to the product manual for more details.
1,MFL62862020, 2018. 1. 3. 1:01 Page 26
Loading ...
Loading ...
Loading ...