Loading ...
Loading ...
Loading ...
17
Step 1
Cleaning the Skin
Clip excess hair from the treatment area. Wash area
with soap and water, and dry completely.
Step 2
Connect Electrodes to Lead Wires
Take the electrodes out of the sealed package and
insert the pin end of the lead wire into each pigtail
connection of the electrodes you plan to use.
Make sure there is no bare metal exposed from the pins.
NOTE: You must use at least 2 electrode pads.
Step 3
Connect Lead Wires to the Device
1. Make sure the device is turned OFF.
2. Holding the insulated portion, push the plug end
of the lead wire into CH1 output socket. If using
all 4 electrodes, repeat for CH2.
NOTE: This device has two output sockets called
channels. You may use one or both channels with
a pair of lead wires on each. Using both channels
gives you the advantage of stimulating two dierent
areas at the same time. If using just one channel,
only connect to CH1 and leave CH2 empty.
TREATMENT SETUP
Loading ...
Loading ...
Loading ...