Loading ...
Loading ...
Loading ...
7
NOTE: Depending on counter top
thickness, it may be easier to access the
mounting nut by disconnecting the cold
water supply hose(s).
Install fastening set as shown: mounting
washer, mounting spacer (if necessary),
and mounting nut. Tighten the mounting
nut with wrench from the underside of
the sink. The mounting spacer is only
needed for installations where the faucet
is mounted directly to a stainless steel
sink, or where the counter top is less
than ½” thick.
Installation
Mounting Washer
Mounting Nut
8
Complete the assembly of the cold water
supply tubing by inserting the 2 - 1/4”
blue poly-tubes already connected to
the faucet into 1/4” tee push fitting. Be
careful not to kink the tubes. Take the
tee tubing, the short piece of blue ¼”
poly-tubing, and connect it to the bottom
part of the ¼” tee and to the 1/4” x
3/8” reducing union fitting. Lastly, take
the part of the black 3/8” poly-tube left
over from Step 4 and connect it to the
1/4” x 3/8” reducing union fitting.
NOTE: Step 8 is only required on Little Butler® Series dispensers that offer
hot and cold water separately (LB_200 Series dispensers). If you have a
Little Butler® hot water only (LB_100 Series) dispenser or a Drinking Water
only (DW_ _00 Series) dispenser, go to Step 9.
3/8” x
1/4”
Reducing
Union
1/4” tee
Push Fit Connections
collar
Mounting Spacer
From
Faucet
From
Faucet
Blue 1/4”
Tee Tubing
9
Take the black 3/8” poly-tubing from the faucet and connect it to the outlet of
the filtration system as outlined in the filtration system instructions. If you decide
not to utilize a filtration system with your LB_100 Series faucet, you must provide
a connection for the black 3/8” poly-tube to the home’s cold water supply.
This will complete the installation for the Drinking Water only (DW_ _00 Series)
dispensing faucets. For Little Butler® Series dispensers (LB_100 and LB_200)
continue to Step 10.
5 6
Loading ...
Loading ...
Loading ...