Loading ...
Loading ...
Loading ...
Page 5
When the heat function is used for the first time, a slight odor may be present. This is
normal and should not occur again unless heater has not been used for an extended
period of time.
Flame Effect / Lightbulb Replacement
Caution: Lightbulbs will become very hot when they are in use. Allow at least ten
minutes for lightbulbs to be cool before touching.
The flame effect on this electric stove heater is created by two 40-watt lightbulbs with an E-12
(small) socket base. Only use 40-watt lightbulbs in this unit. To service lightbulbs, unplug the
power cord from the outlet, and locate the access panel on the back of the stove. Remove the
screws and the panel. Lightbulbs may have come loose, or may have become damaged, during
shipping. If the flame effect does not work properly, check to be certain that both bulbs are
screwed in tightly, and are in working order. Replace the lightbulbs as needed. Replace the
access panel. Do not operate without the access panel in place. Do not remove the back cover
of the heater. There are no serviceable parts inside the heater.
Controls / Operation
After reading the safety instructions, and this entire manual, be certain that the controls are in
the OFF position. The heat and flame affect controls are located on the right side of heater. Your
heater stove is now ready for operation. Plug the unit into a grounded 15-amp with a 110 / 120-
volt outlet. For the flame affect only, slide the ON / OFF switch to the ON position. For low heat,
slide the ON / OFF switch and the I switch. For high heat, slide the ON / OFF switch, and the I
and II switch.
Loading ...
Loading ...
Loading ...