BDCD8PK User Manual

Loading ...

KEYLESS CHUCK (FIGURE C)

WARNING: Makecertainthelock-off

button is engaged to prevent switch

actuation before installing or removing

accessories.

To insert a drill bit or other accessory:

1. Grasp the rear half of the chuck (3)

with one hand and use your other

hand to rotate the front half (3a) in the

counterclockwise direction, as viewed

from the chuck end.

2. Insert the bit or other accessory fully

into the chuck, and tighten securely by

holding the rear half of the chuck and

rotating the front portion in the clockwise direction as viewed from the chuck end.

WARNING: Do not attempt to tighten drill bits (or any other accessory) by gripping

the front part of the chuck and turning the tool on. Damage to the chuck and personal

injury may occur when changing accessories.

SCREW DRIVING

For driving fasteners, the reversing button should be pushed to the left. Use reverse

(button pushed to the right) for removing fasteners. When moving from forward to reverse,

or vice versa, always release the trigger switch first.

DRILLING

•Usesharpdrillbitsonly.

•Supportandsecureworkproperly,asinstructedintheSafetyInstructions.

•Useappropriateandrequiredsafetyequipment,asinstructedintheSafety

Instructions.

•Secureandmaintainworkarea,asinstructedintheSafetyInstructions.

•Runthedrillveryslowly,usinglightpressure,untiltheholeisstartedenoughtokeep

the drill bit from slipping out.

•Applypressureinastraightlinewiththebit.Useenoughpressuretokeepthebitbiting

but not so much as to stall the motor or deflect the bit.

•Holdthedrillfirmlywithtwohands,onehandonthehandle,andtheother

gripping the bottom around the battery area.

•DONOTCLICKTHETRIGGEROFASTALLEDDRILLOFFANDONINANATTEMPT

TO START IT. DAMAGE TO THE DRILL CAN RESULT.

•Minimizestallingonbreakthroughbyreducingpressureandslowlydrillingthroughthe

last part of the hole.

•Keepthemotorrunningwhilepullingthebitoutofadrilledhole.Thiswillhelpreduce

jamming.

DRILLING IN WOOD

Holes in wood can be made with the same twist drill bits used for metal or with spade

bits. These bits should be sharp and should be pulled out frequently when drilling to clear

chips from the flutes.

DRILLING IN METAL

Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass

which should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or

lard oil.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the

tool; never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and

adjustment (other than those listed in this manual) should be performed by authorized

service centers or other qualified service personnel, always using identical replacement parts.

Loading ...

User Manual - Page 7