Loading ...
Loading ...
Loading ...
English | 21
Bosch Power Tools 1 609 92A 1LB | (16.11.15)
Material Disposal
Diluting agent and remainders of spray material must be dis-
posed of in an environmentally-friendly manner. Observe the
manufacturer’s disposal information and the local regulations
for disposal of hazardous waste.
Chemicals harmful to the environment may not be disposed of
into soil, groundwater or bodies of water. Never pour chemi-
cals harmful to the environment into the sewerage system!
Storage
– Before putting the fine-spray system into storage, thor-
oughly clean the fine-spray system and allow all parts to
dry completely before assembling them.
Correction of Malfunctions
Problem Cause Corrective Measure
Spray material does not cover
properly
Spraying capacity too low Turn thumbwheel 5 in direction +
Clearance to target area too large Reduce spray distance
Not enough spray material on target area, too
few spray paths sprayed over target area
Apply more spray paths over target area
Spray material too viscous Dilute the spray material again and carry out a
test-spray run
Spray material runs off after
coating
Too much spray material applied Turn thumbwheel 5 in direction –
Clearance to target area too close Increase spray distance
Viscosity of spray material too low Add original spray material
Spray material applied too often over same spot Remove spray material; reduce number of
spray paths over same spot
Atomisation too coarse
Spraying capacity too high Turn thumbwheel 5 in direction –
PFS 2000: White nozzle cap 9 mounted (nozzle
diameter too large)
Mount the grey nozzle cap 8
Nozzle needle 13 soiled Clean nozzle needle
Spray material too viscous Dilute the spray material again and carry out a
test-spray run
Air filter 26 heavily soiled Changing the Air Filter
Excessive paint mist
Too much spray material applied Turn thumbwheel 5 in direction –
Clearance to spray surface too large Reduce spray distance
Spray jet pulsates
Not enough spray material in container Refill spray material
Ventilation hole 15 on suction tube 12 clogged Clean the suction tube and the ventilation hole
Suction tube 12 loose Slide the suction tube all the way onto the paint
channel 16
Nozzle cap 9/8 loose Tighten the nozzle cap 9/8
Air filter 26 heavily soiled Changing the Air Filter
Spray material too viscous Dilute the spray material again and carry out a
test-spray run
Spray material dripping at the
nozzle cap
Deposit of spray material on the nozzle cap 9/8,
the nozzle needle 13 and the air cap 2
Clean the nozzle cap, nozzle needle and air cap
Nozzle cap 9/8 loose Tighten the nozzle cap 9/8
No spray material coming out
of the nozzle cap
Suction tube 12 loose Slide the suction tube all the way onto the paint
channel 16
Nozzle needle 13 clogged Clean nozzle needle
Suction tube 12 clogged Clean suction tube
Ventilation hole 15 on suction tube 12 clogged Clean the suction tube and the ventilation hole
Container seal 14 missing or damaged Slide a (new) container seal over the suction
tube into the groove
Spray material too viscous Dilute the spray material again and carry out a
test-spray run
Spray material dirty (lumps of paint) Completely empty and clean the spray gun;
pour the spray material through the filling sieve
when filling
OBJ_BUCH-2216-004.book Page 21 Monday, November 16, 2015 9:14 AM
Loading ...
Loading ...
Loading ...