Bromic BH0420032 Heating Tungsten Smart-Heat 4000W Electric Heater

User Manual - Page 4

For BH0420032.

PDF File Manual, 16 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
4
www.bromic.com/heating
IMPORTANT NOTES AND WARNINGS
WARNING
Read all instructions before installing or using this heater
Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause re, electric
shock, or injury to persons.
Improper installation, adjustment, or alteration and failure
to follow the warnings and instructions in this manual could
result in severe personal injury, death or property damage.
The manufacturer is not responsible for any damage that could
happen from improper use. The manufacturer emphasises that
this appliance should be used in a responsible manner and that
all procedures, warnings, and safety instructions contained in
this booklet be followed strictly.
This heater is not intended for use in bathrooms, laundry areas
and similar indoor locations. Never locate heater where it may
fall into a bathtub or other water container.
Do not install the heater directly near a bathtub, shower or
swimming pool. Any switches or controls must not be within
reach of a person in the bathtub, shower or swimming pool.
This heater is hot when in use. To avoid burns do not let bare
skin touch hot surfaces. Keep combustible materials such as
furniture, pillows, bedding, papers, clothes , etc. and curtains
at least 3’ (900mm) from the front the front of the heater and
keep them away from the sides and rear.
Extreme caution is necessary when any heater is used by
or near children or invalids and whenever the heater is left
operating and unattended.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of
the appliance by a person responsible for their safety.
Keep packaging materials out of reach of children
Children and adults should be alerted to the hazards of high
surface temperatures and should stay away to avoid burns,
clothing ignition, or other serious personal injury
Children should be carefully supervised when they are in the
area of the heater.
Do not attempt to alter the unit in any manner.
Do not paint any surface of the heater.
Do not touch the heater with wet hands at any time.
Do not insert or allow foreign objects to enter front cover or
front opening as this may cause an electric shock or re, or
damage the heater
Do not touch the heating surface at any time, even when the
heater is turned o and has cooled down.
Do not use or store ammable materials near this appliance
Do not spray aerosols or ammable materials in the vicinity
of this appliance while it is in operation
Never operate the heater in an explosive environment such as
areas where petrol or other ammable liquids or vapours are
stored.
Clothing or other ammable materials should not be hung
from the heater or placed on or near the heater.
INSTALLATION
IMPORTANT - Installation must be carried out by a licensed and
authorised person.
The installer is to ensure that the requirements of the local
authority, local electrical installation code, municipal building
codes, and any other relevant statutory regulations are carried
out.
After unpacking, make sure the appliance shows no signs
of visible damage or tampering. If the appliance appears
damaged, contact the place of purchase for assistance.
Remove transit protection before use.
This appliance must only be used on a 230-240 Volt AC Single
Phase electricity supply.
This radiant heater is NOT intended to be installed on
recreational vehicles and/or boats.
Do not run cord under carpeting. Do not cover with throw rugs,
runners or the like arrange cord away from trac area and
where it will not be tripped over
A heater has hot and arcing or sparking parts inside. Do not use
it in areas where gasoline, paint or ammable liquids are used
or stored.
To maintain Ingress Protection Rating (IPX4), only IPX4 rated
conduit ttings should be used for electrical installation.
Warning –To Reduce the risk of re with Danger –To Avoid Fire
This Installation, Operation and Service manual should not be
removed from the site of installation. Installer should leave
manual with the customer for future reference.
Any guard or other protective device removed for servicing
(conducted by an authorised person) must be replaced before
operating the heater.
Heaters are not intended to be installed in wardrobes.
The appliance must not be located directly below or in front of
a wall electricity socket. This is because the heat radiated from
the appliance may damage the electricity outlet or plug.
If the appliance has not been used, or will not be used, for a
long period of time, disconnect power supply
A means for disconnection of the heater must be incorporated
in the xed wiring according to the local electrical codes.
Do not mount the heater vertically. Install Heater so that the
infrared elements are
Horizontal. Failure to do this may cause the heating element
within the tube to sag and cause premature burnout. Installing
vertically will void the manufacturers warranty.
CLEARANCE
Do not place articles on or against this appliance
A minimum safety distance of 3’ (900mm) should always be left
in front of the appliance.
Be sure the heater is not facing the ceiling or ammable or
combustible substances/materials.
MAINTENANCE/ REPAIR
Installation and repair must be carried out by a qualied &
licenced service person only. The heater should be inspected
!
Loading ...
Loading ...
Loading ...