Loading ...
Loading ...
Loading ...
15
www.bromic.com/heating
For longest product life & to maintain product appearance
mount heater under cover & protect from rain & weather
whenever possible.
The exterior housing of the heater should be cleaned
regularly with a soft damp cloth. For locations near the
coast, salt in the air can cause rusting of metal. Additional
cleaning of the heater with a soft damp cloth fortnightly will
increase the life of the products appearance.
Ensure that there is no excessive build-up of dirt/dust on
the reectors or elements as this can cause overheating
and premature element failure. To clean the reectors and
elements, ensure heater is o and has been o for at least 2
hours after operation, and wipe o any dirt/dust with a soft
& dry cloth.
MAINTENANCE
SERVICING
TUBE ELEMENT REPLACEMENT
WARNING
ELECTRICAL SHOCK HAZARD!
Serious injury or death may occur.
Disconnect from electrical supply before servicing this
heater.
!
!
WARNING
Servicing and maintenance MUST be carried out by an
authorised and licensed person only
1. Remove Front Cover of the heater by unscrewing the 3
screws holding it in place.
2. Remove rst Element End Cover by unscrewing the 2
screws holding it in place.
3. Remove Outer Hex Nut, Lock Washer and Lead Wire
Ring Terminal from the threaded stud.
4. Remove second Element End Cover by unscrewing the
2 screws holding it in place.
5. Remove Outer Hex Nut, Lock Washer and Lead Wire
Ring Terminal from the threaded stud.
6. Remove old Tube Element.
7. Install new Tube Element by following element installa-
tion instructions on page 8 of this manual.
Loading ...