Loading ...
Loading ...
Loading ...
48
EN
Electrical Connection for Gas hob
Fit the supply cord with a standard plug for the demand rate indicated on the rating
plate or connect it directly to the electrical mains. In the latter case, a single pole switch
must be placed between the hob and the mains, with a minimum opening between the
contacts of 3 mm in compliance with current safety codes (the earthing wire must not be
interrupted by the switch). The power supply cord must be positioned so that it does not
reach a temperature in excess of 50°C than room temperature at any point.
Before actual connection make sure that:
• The fuse and electrical system can withstand the load required by the hob;
• The electrical supply system is equipped with an efcient earth hook-up according
to the norms and regulations prescribed by law;
• The plug or switch are easily accessible.
IMPORTANT: the wires in the main lead are coloured in accordance with the following
code:
• Green & Yellow - Earth
• Blue - Neutral
• Brown - Live
As the colours of the wires in the main lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
• As the colours of the wires in the main lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows: Connect the
Green & Yellow wire to terminal marked "E" or
or coloured Green or Green &
Yellow.
• Connect the Brown wire to the terminal marked "L" or coloured Red.
• Connect the Blue wire to the terminal marked "N" or coloured Black.
Loading ...
Loading ...
Loading ...