Loading ...
Loading ...
Loading ...
29
EN
TROUBLESHOOTING
Problem Possible causes What to do
No power after turning on the
power switch
Controller cord is not
connected to the PCB
Reconnect controller cord
to PCB
Dry burn before adding water
and the thermostat overload
has cut off
Wait for the brewer to cool
down to below 175°C：
Controller display E1 Temperature sensor cord is not
connected to the PCB
Reconnect sensor cord to PCB
Not heating up after you have
nished setting the steps
The start button wasn’t held
down for long enough
Hold down the start button for
3 seconds
Wire connected incorrectly Reconnect wire correctly
Water not being pumped from
the tap
Tap not open Open the tap
Pump and tap not connected Connect the pump to tap with
quick connector
Air or bubbles in the pump Make sure the water level is
higher than the tap inlet, turn
off the pump ,open one of the
valves and then open the tap
to get the air out of the pump
Wort not pumped out Air or bubbles in the pump Make sure the water level is
higher than the tap inlet, turn
off the pump, open one of the
valves and then open the tap
to get the air out of the pump
Filter tube or lter basket is
blocked
Power off the brewer, take all
the wort out when it is cool
enough and clean the lter
tube or lter basket
Wort is too thick and sticky Fill with water
Loading ...
Loading ...
Loading ...