Instruction Manual - Page 7

For OZF3-W. Also, The document are for others Ozeri models: OZF3

Loading ...
Loading ...
Loading ...
SHIFT FUNCTION
As well as the fan speed control, the fan is also equipped with the ability to turn each
of the three dierent fans on or o.
Touch the button. “FAN1”, “FAN2” and “FAN3” will ash on the display for 5
seconds.
During this time, touch the , or buttons to turn FAN1, FAN2 or FAN3
o or on.
NOTE: If all fans are turned o, this is the same as touching the button.
MAINTENANCE
To maintain the airow eciency, clean the inlet and outlet grilles on a regular basis,
rst taking care to observe the following:
· Unplug the fan from the power supply before cleaning.
· Use a soft, damp cloth to wipe the outside. Use only water to dampen the cloth.
Never immerse the fan in water. Never use thinners or other cleaning solutions, as
these may damage the fans surface appearance.
· Use a vacuum cleaner to remove dirt and dust from the inlet and outlet grilles.
· Ensure the fan is completely dry before plugging the cord back into a power supply.
· If the fan will not be used for an extended period of time, unplug the fan and store
it in a cool dry indoor location, taking care to ensure the fan is stored vertically on a
level hard oor.
CAUTION: THIS FAN HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER).
TO REDUCE THE RISK OF ELECTRICAL SHOCK, THIS PLUG IS INTENDED TO FIT IN A
POLARIZED OUTLET ONLY ONE WAY. MATCH THE WIDE BLADE OF PLUG TO THE WIDE
SLOT OF THE OUTLET. FULLY INSERT. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET,
REVERSE THE PLUG. IF IT STILL DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. DO
NOT ATTEMPT TO BYPASS THIS SAFETY FEATURE.
NOTE: THIS FAN IS EQUIPPED WITH A FUSE. ALWAYS UNPLUG THE
FAN BEFORE REPLACING FUSES. IF THIS FAN LOSES POWER AND YOU
SUSPECT THE FUSE IN THE PLUG HAS BLOWN, UNPLUG THE FAN, THEN
SLIDE THE FUSE DOOR FOUND ON THE SIDE OF THE PLUG TO THE
OPEN POSITION. SLIDE THE FUSE DOOR OUTWARD UNTIL THE BLOWN
FUSE IS FULLY VISIBLE. REMOVE THE BLOWN FUSE AND SNAP THE
REPLACEMENT FUSE INTO PLACE. FULLY CLOSE THE FUSE DOOR. ONLY
REPLACE WITH A FUSE RATED AT 2.5 – 5 AMPS, 125 VOLTS.
shIFT
MoDe sWInG TIMeR
7
oFF
Loading ...