Loading ...
Loading ...
Loading ...
Lynx Side Burners & Grill Extender
37
WARNING! Before lighting:
Prior to using the side burners:
Inspect the gas supply piping or hose prior to turning the gas "on". If there is evidence of cuts
wear, or abrasion, it must be replaced prior to use.
The replacement pressure regulators and hose assembly must be the type specified by the man-
ufacturer. Do not use the side burner if the odor of gas is present. The pressure regulator and
hose assembly supplied with the unit must be used. If the unit is L.P., screw the regulator into the
tank and leak check the hose and regulator connections with a soap and water solution before
operating the side burner. Turn all knobs to "off " then SLOWLY turn on the gas supply valve.
Always keep your face and body as far away from the grill as possible when lighting. Do not
attempt to "Light" the side burner if the odor of gas is present. Call for service. Always wait at least
5 minutes before relighting a hot side burnerl.
Match Lighting: If burner(s) will not light after several attempts, they can be match lit. If
you’ve just attempted to light the burner with the igniter, allow 5 minutes for any accumulated
gas to dissipate.
Make sure all knobs are in the OFF position. Keep your face as far away from the burner as
possible. Pass a lit, long stemmed match to the ports of the burner. Push and turn the corre-
sponding control knob of the burner to “Lite”. If the burner does not light in 4 seconds, turn the
knob off and wait 5 minutes before attempting again.
Always wait at least 5 minutes before re-lighting a hot burner!
To Light:
Turn the burner knob to “lite” and push and hold the ignition button, on the
left side, for 5 seconds. You should hear a “clicking” sound. If not, turn all
knobs to “OFF” and check ignition battery (see page 12).
Turn burner control knob to light. If the burner does not light in 4 seconds,
turn knobs to "OFF".
Burners
Control Knob
Lighting Instructions
Rev. 04/2005
Loading ...
Loading ...
Loading ...