Loading ...
Loading ...
Loading ...
16
8. Using pliers, tighten the couplings with an additional two-thirds
turn.
A
A. Inlet to cold water
NOTE: Do not overtighten. Damage to the coupling can result.
9. Attach
other end of long hose to fill valve at bottom of dryer back
panel. Screw on coupling by hand until it is seated on fill valve
connector.
10. U
sing pliers, tighten the coupling with an additional two-thirds
turn.
NOTE: Do not overtighten. Damage to the coupling can result.
11. Check that the water faucets ar
e on.
12. Check for leaks ar
ound “Y” connector, faucet, and hoses.
Level Dryer
Check the levelness of the dryer by first placing a level on the top of
the dryer near the console.
Then, by placing a level in the crease on the side of the dryer
be
tween the top of the dryer and the dryer cabinet, check the
levelness from front to back.
If the dryer is not level, prop up the dryer using a wood block. Use a
wrench to adjust the legs up or down and check again for levelness.
Reverse Door Swing
You can change your door swing from a right-side opening to a left-
side opening, if desired.
1. Place a towel or soft cloth on top of the dryer or work space to
avoid damaging the surface.
Remove the door assembly
1. Open
the dryer door.
2. Remove the bottom scr
ew from each of the 2 hinges that attach
the dryer door to the front panel of the dryer.
3. Loosen th
e top screw from each of the 2 hinges in Step 2.
A
B
A
B
A. Loosen these screws.
B. Remove these screws.
4. Remove the dryer door and the hinges by lifting upward on the
door. Lay the door on a flat, protected surface, with the inside of
the door facing up. Remove remaining 2 loose screws from dryer
fr
ont panel.
Loading ...
Loading ...
Loading ...