Loading ...
Loading ...
Loading ...
6 INSTALLATION
6.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
6.2 INSTALL THE BATTERY PACK
Figure 2.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2.
Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
6.3 REMOVE THE BATTERY PACK
Figure 3.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
6.4 INSTALL THE BIT
Figure 4.
1. Push reversing button in the center position to lock
the switch trigger.
2. Open or close the chuck jaws to a point.
3. Lift the front of the machine to keep the bit from
falling out of the chuck jaws.
4. Put the bit into the point.
5.
Tighten the chuck jaws.
NOTE
Turn the chuck body to close the chuck jaws. Do not
use a wrench to tighten or loosen the chuck jaws.
WARNING
Put the bit straight into the chuck jaws. Do not put the
bit into the chuck jaws at an angle then tighten.
6.5 REMOVE THE BIT
Figure 5.
1. Push reversing button in the center position to lock
the switch trigger.
2. Open the chuck jaws.
3. Remove the drill bit.
WARNING
Be prepared for binding at bit breakthrough. When
these situations occur, drill has a tendency to grab and
kick opposite to the direction of rotation and could
cause loss of control when breaking through material.
If not prepared, this loss of control can result in
possible serious injury.
7 OPERATION
WARNING
Always wear eye protection.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
7.1 START THE MACHINE
Figure 6.
NOTE
The machine can not work until the reversing button is
pushed fully to the left or right. Do not operate the
machine at low speeds for extended periods of time.
1. Push the switch trigger to turn the machine ON (I).
7.2 STOP THE MACHINE
Figure 6.
1. Release the switch trigge to turn the machine OFF
(O).
5
English
EN
Loading ...
Loading ...
Loading ...