Loading ...
Loading ...
Loading ...
14 | English
F 016 L81 412 | (18.1.16) Bosch Power Tools
Mounting and Operation
Working Advice
Starting
To start your Shredder, rotate the On/Off switch from posi-
tion “0” to position “II”. Allow machine to start and release
switch, which will return to position “I” (the normal run posi-
tion).
Note: The machine will not start if the On/Off switch is pushed
in slightly, whilst being rotated.
As a safety feature the machine will not start unless the hop-
per securing knob is fully tightened.
Restarting Protection
A mains failure causes machine to switch off. The machine
cannot restart on its own when the power returns.
Overload Protection
Overloading (e. g. blocking up of the cutter) can lead to a
standstill of the machine after a few seconds. After a short pe-
riod, the machine can be switched on again. If the machine
blocks again turn it off.
Remove blockage and restart.
Advice on Shredding
Branches become harder to shred depending on the type, age
and dryness of the wood.
For best results, shred fresh branches soon after they have
been cut.
Soft garden waste should be shredded in smaller loads, par-
ticularly when wet. Any blockages can be avoided by intermit-
tently shredding branches.
Blade Maintenance
Stop and remove plug from the power supply.
The blade has a double sided cutting edge.
When the cutting edges become blunt, the blade can be
turned over. The blade bolt may only be reused once, do not
reuse or use a non approved blade bolt. When both sides are
blunt replace the blade.
When fitting a new blade, discard old bolt and only use a
Bosch approved bolt, supplied.
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your garden product does not operate
properly. If these do not identify and correct the problem, contact your service agent.
Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled.
Action Figure Page
Delivery Scope 1 198
Mounting wheels and undercarriage 2 198
Mounting the collecting bag and base
unit bearn 3 199
Connecting the Extension Lead 4 199
Starting 5 200
Working Advice 6 200
Stopping 7 201
Blade Maintenance 8 201
Maintenance, Cleaning and Storage 9 202
Selecting Accessories 10 202
Problem Possible Cause Corrective Action
Machine fails to operate Switch fails to operate Do not push On/Off switch while it is being rotated
Securing knob has not been fully tightened Tighten securing knob
Power turned off Turn power on
Mains socket faulty Use another socket
Extension cable damaged Inspect cable, replace if damaged
Fuse faulty/blown Replacse/restart
Motor protector has activated Follow “Overload Protection” procedure
Power supply interrupted Follow “Overload Protection” procedure
On/Off switch returns to position “0” Allow machine to cool then follow “Overload Protec-
tion” procedure
Machine functions
intermittently
Extension cable damaged Check mains cable and have it replaced, if required
Internal wiring of machine damaged Contact Service Agent
Motor protector has activated Follow “Overload Protection” procedure
On/Off switch returns to position “0” Allow machine to cool then follow “Overload Protec-
tion” procedure
Loading ...
Loading ...
Loading ...