Loading ...
Loading ...
Loading ...
24
|
Gas Requirements
The tip of the spark plug or thermocouple must fully overlap at
least the rst gas emission hole of the burner. After performing
all these visual checks, reinstall the bottom panel of the oven
compartment and proceed to setting the minimum for each
burner.
STEP 6: MINIMUM FLAME ADJUSTMENT
WARNING! These adjustments should be made only for use of
the appliance with natural gas. For use with liquid propane gas,
the By-pass screw must be fully turned in a clockwise direction.
SURFACE BURNERS
1. Light one burner at a time and set the knob to the MINIMUM
position (small ame).
2. Remove the knob.
3. The range is equipped with a safety valve. Using a small size
slotted screwdriver, locate the By-pass screw valve on the
valve body and turn it to the right or left until the burner
ame is adjusted to desired minimum.
4. Make sure that the ame does not go out when switching
quickly from the MAXIMUM to the MINIMUM position.
For surface hob burners
For simmer burners, on the tap in the right
OVEN BURNER
1. Set the oven temperature control knob to the MAXIMUM
setting.
2. Close the oven door and operate the oven for at least 10
minutes.
3. Set the knob to the MINIMUM setting
4. Remove the knob.
5. With a slotted screwdriver turn the choking screw (bypass
screw at the left side of the thermostat bar) and, while
observing the ame at the same time through the bottom
oven porthole, evaluate the consistency of the ame so it
remains on when switching quickly from MINIMUM to
MAXIMUM setting.
Loading ...
Loading ...
Loading ...