NY90T5010SS/FA User & Installation manual

Loading ...

REDUCED GAS FLOW RATE SETTING FOR HOB TAPS

1. Ignite the burner that is to be adjustment and turn the knob

to the reduced position.

2. Remove the knob from the gas tap.

3. Use an appropriately sized screwdriver to adjust the ow

rate adjustment screw. For LPG (butane-pro pane) turn the screw

clockwise. For the naturel gas, you should turn the screw counter-

clockwise once.

“The normal length of a straight ame in the reduced position

should be 6-7 mm.“

4. If the ame is higher than the desired position, turn the screw

clockwise. If it is smaller turn anticolockwise.

5. For the last control, bring the burner both to hight-ame and

reduced positions and check whether the ame is on or off.

Depending on the type of gas tap used in your appliance the

adjustment screw position may vary.

To adjust your oven acc. to the gas type, make the adjustment

for reduced ame carefully by turning with a small screwdriver

as shown below on the screw in the middle of the gas cocks as

well as nozzle changes (gure 6).

WARNING: Do not completely remove the ow rate adjustment

screw from the valve stem. The ow rate adjustment screw is an

integral part of gas valve assembly. Removing the ow rate

adjustment screw will cause gas to leak. After adjusting the ow

rate adjustment screw, inspect the assembly for gas leaks.

Figure 6

Loading ...

Samsung NY90T5010SS/FA 95L 90cm 5 Gas Burner With Triple Flame Wok Plate