Loading ...
Loading ...
Loading ...
31-5000500 Rev. 0 5
ENGLISH
READ AND SAVE THESE INSTRUCTIONS
FOR MORE HELP, VISIT HAIERAPPLIANCES.COM OR CALL THE CONSUMER HELP LINE AT 877-337-3639.
• Do not put any heating apparatus under the indoor units.
The heat may cause distortion of the units.
• Pay attention to the ventilation to avoid anoxic injury.
• Do not place an open flame in the path of blowing air.
• Do not install in a corrosive environment. If the base
collapses, the unit may fall and cause damage, product
failure, personal injury or death.
• Do not use the unit for special purposes such as
preserving foods, works of art etc. It is an air conditioner
for comfort cooling / heating, not a precision refrigeration
system.
• Size circuit breaker per local or national codes, improper
breaker or fuse may lead to fire, electric shock, explosion,
personal injury or death.
• Turn off the power to save energy if the unit will be not
used for a long period. The unit continues to use power
even though the equipment is turned off at the controller.
• Do not permit water to enter the unit and the wired
controller. There is risk of unit failure, fire, electric shock,
personal injury or death.
• 3-minutes protection
To protect the unit, there is a 3-minute time delay after
the unit stops or after power is applied.
• Close the window to avoid outdoor air getting in. Curtains
or window shutters can be put down to avoid the sunshine.
• Do not touch the power switch with wet hands to avoid
power shock.
• Turn off the system and remove power when servicing
the unit.
• Turn equipment off at the control before isolating power.
• Do not clean the unit with water spray. There is risk of
damaging the unit, fire, electric shock, personal injury
or death.
• Keep flammable gas or combustibles away from the unit.
There is risk of product failure, fire, personal injury or
death.
• Please keep children away from this air conditioning
equipment.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for
local inspector’s use.
• IMPORTANT – Observe all governing
codes and ordinances.
• Note to installer – Be sure to leave these instructions
with the Consumer.
• Note to consumer – Keep these instructions for future
reference.
• Skill level – A licensed certified technician (to handle
refrigerant R-410A, recovery, etc) and a qualified
electrician are required for installation and service of
this split heat pump system.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the limited warranty.
• For personal safety, this system must be properly
grounded.
• Protective devices (fuses or circuit breakers) acceptable
for installation are specified on the nameplate of each
unit.
• Make sure to avoid wiring or plumbing inside the wall
when installing.
CAUTION
• Aluminum electrical wiring may present special
problems - consult a qualified electrician.
• When the unit is in the STOP position, there is still
voltage to the electrical controls.
CAUTION
IMPORTANT SAFETY INFORMATION
Loading ...
Loading ...
Loading ...