Loading ...
Loading ...
Loading ...
ENGLISH
PAGE 18 USING YOUR AIR CONDITIONER
STARTING THE AIR CONDITIONER cont.
1. Carefully remove the clear plastic film from the control panel.
2. Press POWER once to turn on the air conditioner.
NOTE: When the air conditioner is first plugged in, the LED display will show “88” for 3 seconds.
After the air conditioner is turned on for the first time, the display will show the
temperature 72˚F and the fan is automatically set to Low speed and the Mode indicator will
show ENERGY SAVE.
• To switch between °F and °C,press UP and DOWN buttons simultaneously and hold for 3
seconds.
NOTE: To switch the temperature display between Fahrenheit (F) and Celsius(C), the air
conditioner must be plugged in, and turned on. The change cannot be done using the
remote control.
3. Select Mode. Refer to “Mode.”
4. Select Speed. Refer to “Speed.”
5. Set Timer. Refer to “Temp/Time”
6.
Reset the filter check reminder. Refer to “Filter Reset”
MODE
1. Press mode until you see the indicator light come on next to the desired setting.
2. Choose Fan, Energy Save, Cool or Dehum.
FAN - Only the fan runs. Press SPEED to select High, Med or Low fan speed. The display shows
the current room temperature.
NOTE: In FAN mode, the temperature cannot be set.
ENERGY SAVE - In this mode the fan runs only when cooling is needed. The fan will run for
3 minutes after the compressor shuts off. The fan then cycles on for 1 or 2
minutes at 10 minute intervals until the temperature in the room is above the
set temperature. The compressor then turns back on.
COOL - Cools the room. Press SPEED to select High,Med , Low or Auto Cool fan speed. Press
the TEMP/TIME up or down arrow button to adjust the temperature.
The fan will run
continuously in cool mode.
DEHUM - Aids in removing humidity from the room. Dehum mode cannot be used to cool the
room.
NOTE: In Dehum mode, when the set temperature is close to the ambient temperature,
the compressor may stop and the fan will run in low speed only.
Loading ...
Loading ...
Loading ...