Loading ...
Loading ...
Loading ...
6. Stand the cart on end with the front angle clamp down on
the oor. Temporarily place the four #1 at washers on the
inside of the front angle clamp (Fig. 6).
7. Lay the front panel down onto the front angle clamp, on
top of the four #1 at washers (Fig. 7).
NOTE: The washers are used here as shims (spacers) and not
for assembly. They will be removed and used for wheel and
axle assembly.
8. Position a side panel against a side angle clamp, resting
on top of the front panel (Fig. 8).
9. Secure a supporting strap on the side angle clamp and
the front angle clamp by two M6 x 25 screws, four #2 at
washers, and 2 hex nuts (Fig. 9).
10. Secure the side panel with the side angle clamp by a
M6 x 25 screw, two #2 at washers,
and a hex nut (Fig. 10).
11. Secure the side panel with the front angle clamp by a
M6 x 25 screw, two #2 at washers, and a hex nut
(Fig. 11).
Fig. 6
Flat washers #1
Fig. 7
Front panel
Fig. 8
Side angle
clamp
Front panel
Side panel
Bottom
panel
M6 x 25
screw
Fig. 9
Supporting
strap
Flat
washers #2
Hex nuts
Side panel
Front
panel
Front angle
clamp
Side angle
clamp
Flat
washers #2
Fig. 10
Side
panel
Side angle
clamp
M6 x 25
screw
Hex nut
Front
panel
Bottom
panel
Flat
washer #2
5
Loading ...
Loading ...
Loading ...