Loading ...
Loading ...
Loading ...
7
4. Unscrew the plug underneath the cover and lift the plug and lter assembly out of the base (Fig B).
5. Remove the lter from the plug by twisting it (g C).
6. Rinse the lter under a tap to remove any deposits. Use a soft brush if necessary.
7. Replace the lter onto the plug and twist it until it locks.
8. Ret the plug and lter assembly into the base and tighten it rmly. Close the cover.
9. Plug in your steam generator.
10. Reset the warning light by pressing and holding the anti-scale warning light/reset button (a) for 3
seconds until the light goes out.
11. Once the appliance is ready, pull the steam trigger until the steam is being produced. This will prime
the system.
Important: Using the appliance without cleaning the lter can cause a reduction in the generated steam
output and damage the appliance. The guarantee will not cover damage caused to the appliance by not
cleaning the anti- scale lter when required.
Do not clean the anti-scale lter in a dishwasher. Wash by hand only using a soft bristled brush if necessary.
TROUBLESHOOTING
Your steam generator is programed to check itself when it is switched on. If a problem is detected and the
unit is not able to operate correctly, the steam trigger will stop working, the thermostat light will ash and
the unit will beep continuously. If this should happen, stop using your steam generator.
Light Flashing Beeps Status
Anti-scale warning light (a) ashing
3 Anti-scale lter needs cleaning
Thermostat light and on/o button ashing - Auto shut o activated
Low water light (d) ashing
2 Water tank empty
Thermostat light ashing - Iron is heating up
Thermostat light ashing Continuous Internal error. Discontinue use.
Loading ...