Loading ...
Loading ...
Loading ...
6
Steam ironing
1. Set the steam control to the setting you want, n. = no steam, x= high steam.
2. Squeeze the steam trigger to produce steam, release it to stop.
• Your steam generator produces steam very eciently so use the trigger in short, controlled bursts.
Too much steam can wet the fabric or cause condensation issues on your ironing board. Steam can
also be reduced by setting the steam control to a lower setting.
NOTE: When you rst start your steam generator and pull the trigger for steam ironing, there will be
a delay as your steam generator pumps water from the reservoir to prime the system. This is normal
and may take 20-30 seconds. This will also happen after relling the reservoir.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
• Check that there’s adequate ventilation behind the fabric, otherwise moisture may build up, causing
mildew.
• Check that there’s nothing behind the fabric that may be damaged by the steam.
• Check that pockets, turn-ups, and cus are empty.
1. Hold the iron close to (but not touching) the fabric. Hold it well away for delicate fabrics.
2. Squeeze the steam trigger to produce steam, release it to stop.
AFTER USE
1. Put the iron on top of the base unit.
2. Turn the unit o by pressing the on/o button.
3. Empty the reservoir.
4. Let the iron cool down completely before cleaning it, moving it, or storing it away.
5. The steam pipe can be coiled together and placed into the hose clip.
6. Wrap the mains cable around the steam generator then slot the plug into the plug storage socket.
CARE AND MAINTENANCE
1. Unplug the base unit, and let the appliance cool down fully.
2. Wipe outer surfaces with a damp cloth. If necessary, use a little washing-up liquid.
3. Remove spots from the soleplate with a little vinegar.
4. Take care not to scratch the soleplate
ANTISCALE FILTER
To extend the life of the appliance and to avoid problems with lime scale, your steam generator is tted with
an anti-scale lter. When the anti-scale lter needs cleaning, the anti-scale lter warning light (a) will come
on. If the warning light comes on when you are ironing you can continue without cleaning the lter. The
next time you use your steam generator the light will ash and the unit will beep three times. The lter must
be cleaned before using your steam genreator again.
Before attempting to remove and clean the lter you must unplug and allow the appliance to stand
for at least 1 hour to allow any built up steam and heat to dissipate.
To clean the lter:
1. Switch o and unplug your steam generator
2. Remove the iron from the top of the generator to expose the cover beneath.
3. Open the cover.
Loading ...
Loading ...