Loading ...
Loading ...
Loading ...
6
!
CAUTION
!
CAUTION
NOTE
INSTALLING THE ANTI TIP DEVICE
Figure 5
Bottom View of
Beer dispenser
Anti-Tip
Bracket
Leveling Leg
Front of cabinet
21
1
⁄2"
(54.6 cm)
Anti-Tip Device
If your beer dispenser is not located under a counter top
(free standing), you must use an anti-tip device installed
as per these instructions. If the beer dispenser is removed
from its location for any reason, make sure that the device
is properly engaged when you push the beer dispenser
back into the original location. If the device is not properly
engaged, there is a risk of the beer dispenser tipping over,
with the potential for property damage or personal injury.
If installing on a concrete oor, concrete fasteners are
required, (not included with the anti-tip kit).
Any nished ooring should be protected with appropriate
material to avoid damage when moving the unit.
Step by step instructions for locating the
position of the bracket:
1) Decide where you want to place the beer dispenser.
Slide it into place, being careful not to damage the oor,
leaving 1" (2.5 cm) of clearance from the rear wall to allow
room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
1
⁄4" (6 mm) to
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the beer dispenser is in the desired loca-
tion, then mark on the oor the rear and side corner of the
cabinet where the anti-tip bracket will be installed. If the
installation does not allow marking the rear corner of the
cabinet, then make temporary lines on the oor marking
the front corner of the cabinet, excluding the door. Slide
the beer dispenser out of the way. From the temporary line
extend the sidewall line back 21
1
⁄2" (54.6 cm) as shown in
Figure 6.
4) Align the anti-tip bracket to the marks on the oor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
1
⁄2" (54.6 cm) line (Rear of cabinet
line).
5) Fasten the anti-tip bracket to the oor using the supplied
screw. (See Figure 6).
6) Slide the cabinet back into position, making sure the
rear cabinet leveling leg slides under the anti-tip bracket
engaging the slot.
Floor Mount Installation
The anti-tip bracket is to be located on the oor in the left or
right rear corner of the beer dispenser as shown in
Figure 5.
!
WARNING
• ALL APPLIANCES CAN TIP
RESULTING IN INJURY.
• INSTALL THE ANTI-TIP
BRACKET PACKED WITH
THE APPLIANCE.
• FOLLOW THE INSTRUC-
TIONS BELOW
Loading ...
Loading ...
Loading ...