Loading ...
Loading ...
Loading ...
15
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figures 16 and 17 for a left hand door
model or Figures 18 and 19 for a right hand door model.
Overlay panel
ush with top
of door.
Holes in
gasket
retainer.
Overlay panel to
be centered on
width of door.
Figure 15
Figure 15a
Step 2: Remove the door gasket
With the door laying on a at surface and starting at a
corner of the door remove the magnetic door gasket from
the interior side of the door, see Figure 15. Set the gasket
aside on a at surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack.
Press and hold down this
tab on the wire connector
and pull the connector apart.
Figure 14
OVERLAY DOOR PANEL INSTALLATION
Loading ...
Loading ...
Loading ...