Loading ...
Loading ...
Loading ...
15
Step 3: Attach the Overlay Panel to the Drawer
1. Set the overlay panel on drawer front face and align
edges. (See Figure 19). The custom overlay panel
should be ush with the top of the drawer and centered
on the width of the drawer. Clamp panel in position and
mark pilot hole locations. Pick the required pilot hole
size from "Table A" below and drill the pilot holes ensur-
ing not to drill all the way through the overlay panel.
Table A: Pilot Hole Drill Sizes for Wood Screws
Material Type #8 Wood Screw
Hardwood
1
⁄8 Diameter Pilot Hole
Softwood
7
⁄64 Diameter Pilot Hole
2. Insert wood screws through clearance holes and
tighten to secure overlay panel.
3. Reinstall gasket into channel. Make sure the corners
are fully inserted.
4. Place the drawer divider back into the drawer.
Figure 19
Overlay panel
ush with top
edge of drawer
Using clearance holes in
gasket channel mark
hole locations onto panel
Screw clearance
hole through
gasket extrusion
Panel
thickness
Figure 18
Figure 19a
14
29
⁄32"
(379 mm)
19"
(483 mm)
1
3
⁄16"
(30 mm)
1"(25 mm) diameter counter
bore
1
⁄4" (6 mm) deep
2 places, top drawer only.
Custom overlay
panel to be cen-
tered on width of
drawer.
11
7
⁄8"
(302 mm)
11
⁄32"
(8.8 mm)
1
⁄2" (12.7 mm)
diameter, top
drawer only
13
⁄16" (21 mm)
counterbore
7
⁄16" (12 mm)
deep, top
drawer only
This side
facing interior
2
3
⁄8"
(60 mm)
23
3
⁄4"
(603 mm)
OVERLAY DRAWER PANEL INSTALLATION
Loading ...
Loading ...
Loading ...