Loading ...
Loading ...
Loading ...
NATURAL GAS CONVERSION PROCEDURE
Please contact Eurostyle to request a Natural Gas Regulator Kit if the appliance is being converted to Natural
Gas.
Conversions only to be done by an authorized person.
A restraining tether or bracket is required to be fixed to the appliance and to the wall within 50mm of each
connection point. The length of the tether shall not exceed 80% of the length of the natural gas hose
assembly.
Tools required
Socket head screw driver (Included with the product)
Wrench
Gas Piping
A minimum pipe with diameter 15mm is required for inlet piping. A lever operated shut-off valve should be
installed within 1 meter of the appliance for servicing the appliance.
Where it is not practical to install solid copper pipe to AS/NZS 5601.1, hose assemblies certified to AS/NZS 1869 or
limited flexibility connectors certified to AS 4631 may be used. The internal diameter of the hose must not be less
than 10mm. The hose should be as short as practicable in accordance with AS/NZS 5601.
All gas pipe connections must be sealed with a gas pipe compound resistant to natural gas. Remove LPG hose
and regulator and ensure the Natural Gas regulator supplied with the appliance is used.
NOTE TO INSTALLERS
For main burner, the U-LPG jet is 0.98mm, the NG jet is 1.50mm
For back burner, the U-LPG jet is 0.98mm, the NG jet is 1.65mm
Both U-LPG injector and NG injector are installed together like right photo shows. The BBQ is set for U-LPG by
manufacturer.
Test operation of appliance such as leak-tightness, burner flames at high and low, and instruct user on safe
operation before leaving.
If the appliance cannot be adjusted to perform correctly contact your distributor or the manufacturer for
assistance. Contact Number: 08 8165 1012
Loading ...
Loading ...
Loading ...