Loading ...
Loading ...
Loading ...
16 17
2
|
TIPS & MAINTENANCE
CARING FOR YOUR BREWER
CLEANING THE KCUP® POD HOLDER ASSEMBLY
Cleaning the Parts The K-Cup® Pod Holder Assembly can be placed
onto the top shelf of a dishwasher. NOTE: Use low temperature
cycles in the dishwasher. To remove from the brewer, lift the
Handle and grasp the top of the K-Cup® Pod Holder with one hand
while pushing up on the bottom of the K-Cup® Pod Holder from
underneath with the other until it releases. After cleaning, align the
K-Cup® Pod Holder with the opening using the two front ribs as a
guide and snap into place from the top.
Cleaning the Funnel The Funnel can be removed from the
K-Cup® Pod Holder by pulling on it until it pops off. The Funnel
is dishwasher safe. To replace it, just snap it back onto the
K-Cup® Pod Holder Assembly.
Cleaning the Exit Needle The Exit Needle is located on the inside
bottom of the K-Cup® Pod Holder Assembly. Should a clog arise due
to coffee grinds, it can be cleaned using a paper clip or similar tool.
Remove K-Cup® Pod Holder Assembly and detach Funnel. Insert the
paper clip into the Exit Needle to loosen the clog and push it out.
The K-Cup® Pod Holder is dishwasher safe.
CAUTION: There are sharp needles that puncture the K-Cup® pod above the K-Cup® Pod Holder and in
the bottom of the K-Cup® Pod Holder. To avoid risk of injury, do not put your fingers in the K-Cup® Pod
Assembly Housing.
CLEANING THE WATER RESERVOIR & WATER RESERVOIR LID
The Water Reservoir Lid and Water Reservoir should be periodically inspected and cleaned.
The Water Reservoir Lid or Water Reservoir should not be put into the dishwasher. They
should be cleaned with a damp, soapy, non-abrasive cloth and rinsed thoroughly. Do not
dry the inside of the Water Reservoir with a cloth as lint may remain.
To clean the filter screen at the base of your Water Reservoir, empty the Water Reservoir
and follow one or all of the following procedures.
NOTE: If you are using a water filter inside the Water Reservoir, remove it before cleaning.
1. Rinse the filter screen with the strong force of water from your faucet.
2. If you have a sprayer, aim the water spray at the filter screen.
3. Fill the Water Reservoir with approximately two inches of clean water and agitate (shake)
the Water Reservoir.
Empty the Water Reservoir then fill it with clean water and return it to the brewer.
If needed, repeat above procedures.
CAUTION: Please rinse the Water Reservoir thoroughly after cleaning. This will ensure that no cleaners or cleaning solutions remain
in this area as they may contaminate the water supply in the brewer.
Loading ...
Loading ...
Loading ...