Loading ...
Loading ...
Loading ...
10 11
SETUP
2. Place a large mug (10 oz. minimum) on
the Drip Tray Plate.
3. Remove the Water Reservoir from
brewer by first removing Lid from
Reservoir, then lifting Reservoir straight
up and away from brewer (may be
tight). Rinse with fresh water. Fill Water
Reservoir with bottled or filtered
water so that the water is to and not
beyond the MAX FILL line.
5. Press Power Button found on upper right
panel of the brewer. The green Power
Light will illuminate.
NOTE: A K-Cup® pod should not be used for this sequence.
NOTE: If the Water Reservoir is empty or not in place on the
brewer, the blue Add Water Light will illuminate. The Small
Mug Button will not be activated until water is added to the
Water Reservoir.
4. Place Water Reservoir base into the left
side of the brewer and be sure the Water
Reservoir Lock Tabs engage with the
brewer. Replace Lid on Water Reservoir.
6. The brewer will automatically fill with
water and then the water will be heated.
This will take about 4 minutes. During the
heating period, the red Heating Light will
illuminate. Once the water is heated, the
red Heating Light will turn off and the
Small Cup, Small Mug, and Large Mug
Buttons will illuminate.
NOTE: Do not lift Handle during this
heating period.
NOTE: You may see small amounts
of water coming from the Vent and
dripping into the Water Reservoir
during this and subsequent heating –
this is normal.
1
|
LET’S GET BREWING!
1. Unwrap cord and plug the brewer into
a grounded outlet. Remove all pieces of
packing tape.
7. Lift and lower the Handle. Press the
Small Mug Button to start a cleansing
brew. Pour the hot water into the sink.
8. The brewer may take 15 seconds to
reheat water between brews during
which time the red Heating Light may be
illuminated. When the water has heated,
the red Heating Light will turn off. The
one-time setup process is now complete
and you are ready to brew!
Loading ...
Loading ...
Loading ...