Loading ...
Loading ...
Loading ...
10
SECTION 3
Cleaning & Maintenance
(continued)
Cleaning the Water Tank
To access the Water Tank, press the PRESS TO OPEN Button and then lower
the Handle completely, the Water Tank Lid will pop open. Inspect the Water
Tank area and clean with a damp, lint free, non-abrasive cloth as necessary.
Close the Water Tank Lid when finished.
Emptying the Water Tank
1. Ensure that the Water Tank Lid is closed.
2. Place a cup on the Drip Tray Plate then press and hold the BREW Button
until all the water has been dispensed. NOTE: There will be a delay of four
to five seconds before water starts to dispense.
Storage
Empty the Water Tank before storing and ensure that you store your brewer
in a safe and frost free environment. It is suggested to store your brewer in
the upright position. If you store the brewer in a cold environment, you run
the risk of condensation freezing inside the brewer and causing damage.
When you prepare to use it after storage, we recommend wiping the Water
Tank with a damp, lint free, non-abrasive cloth and running three cleansing
brews without a K-Cup
®
pod.
If the brewer has been in an environment below freezing, please be sure to
let it warm to room temperature for two hours before using.
• After pressing the BREW Button, just after the brewer starts to dispense,
press the Power Button to turn the brewer off. Allow the brewer to sit for
at least 30 minutes. Power off the brewer just after it starts to dispense
and then allow it to sit for at least 30 minutes.
• After 30 minutes have passed, place the mug on the Drip Tray Plate and
press the BREW Button.
DO NOT USE A K-CUP
®
POD
• Discard the hot contents into sink.
• If you can still see scale in the Water Tank, repeat Step 2.
STEP 3: FRESH WATER RINSE
• Repeat Step 1 (three times) substituting the Descaling Solution for 8 oz. of
fresh water each time.
• You may need to perform additional Fresh Water Rinse cycles if you notice
any residual taste.
NOTE: The cleaning action of Keurig
™
Descaling Solution may result in a foam
dispensed from the brewer. This is natural, as the solution is reacting with
the scale inside. For a brewer that is heavily scaled, the brewer may not fill
properly after the descaler is added. If this occurs, you may see only a small or
no output dispensed followed by the sound of air blowing out. If this occurs:
• Turn off and unplug the brewer.
• Plug the brewer back in, power on, and repeat the Step 3 Fresh Water
Rinse cycle. The brewer should begin to function normally as the solution
is rinsed out and the scale is removed. If problem persists, allow brewer to
sit unplugged for at least 30 minutes before continuing with the rinse.
For further descale information please contact your Keurig Authorized
Distributor.
Loading ...
Loading ...
Loading ...