Loading ...
Loading ...
Loading ...
8
9
adding Water
The LCD Control Center will indicate “ADD
WATER” when the level in the Water Reservoir
is low or if the Water Reservoir has been removed
(fig. 8). The blue light in the Water Reservoir
will also blink when water needs to be added.
The brewer will not allow you to brew when “ADD
WATER” is indicated.
The Water Reservoir can be filled in two ways.
1.
Remove the Water Reservoir Lid and pour water
directly into the Water Reservoir while it is still
attached to the brewer. Fill with water to and not
beyond the MAX FILL line. Replace the Lid.
2. Remove the Water Reservoir from brewer by first removing the Lid from
the Water Reservoir, then lifting the Water Reservoir straight up and away
from brewer. Fill with water to and not beyond the MAX FILL line. Place
the Water Reservoir back on the brewer and replace the Lid. IMPORTANT:
Do not remove the Water Reservoir during the brewing process.
Brewing Iced Beverages
Your iced tea and iced coffee taste best when fresh-brewed hot over ice. Try it by
placing a tall cup filled with ice on the Drip Tray Plate (the Drip Tray Assembly
can be removed to accommodate taller cups), choose your favorite K-Cup
®
pack and press your preferred brew size. Also, look for the Brew Over Ice icon
on K-Cup
®
packs that are specially crafted to brew over ice! IMPORTANT: Do not
brew into a cup made of glass. Doing so may cause the glass to crack or break.
Brewing hot Water
Your brewer is able to produce hot water for making hot cocoa from a packet,
for use in cooking, for making soups, etc. Simply follow the instructions on
page 7 — “Ready To Brew Your First Cup” — without adding a K-Cup
®
pack.
NOTE: After brewing a hot cocoa K-Cup
®
pack, we recommend running a
cleansing brew without a K-Cup
®
pack.
Purging the Brewer
If your brewer has not been used for more than one week, you should purge
the water from the internal tank.
1. If there is water in the Water Reservoir, remove the Lid, then lift the
Water Reservoir straight up and away from brewer. Discard water, rinse
and refill with water. Place the Water Reservoir back on the brewer and
replace the Lid. (If there is no water in the Water Reservoir, simply refill.)
2. Be sure the brewer is turned on. Lift and lower the Handle on the brewer
without inserting a K-Cup
®
pack.
3. The LCD Control Center will indicate “READY TO BREW” and the Small
Cup, Small Mug and Large Mug Buttons will flash. Be sure to have a
large mug on the Drip Tray Plate and then press the Large Mug Button.
4. Repeat steps 2 and 3 one more time to completely purge water from
internal tank.
If you are experiencing any problems with your brewer, please contact
Customer Service at 1.866.901.BREW (2739).
fig.
8
dtp1005-001900 ctp09
P9 201309003 KER755_K60-65.pdf 1C( K) ZB2319 2013.09.06
Loading ...
Loading ...
Loading ...