Loading ...
Loading ...
Loading ...
7
6
ready to Brew Your First cup
1. LCD Control Center will indicate
“READY TO BREW.”
2. Place a cup or mug on the Drip Tray Plate.
3. Lift the Handle and the K-Cup
®
Pack Holder
will open toward you (fig. 6).
4. Select a K-Cup
®
pack.
NOTE: Do not remove the foil
lid or puncture the K-Cup
®
pack.
5. Place a K-Cup
®
pack in the
K-Cup
®
Pack Holder (fig. 7).
CAUTION: There are two sharp needles that
puncture the K-Cup
®
pack, one above the
K-Cup
®
Pack Holder and the other in the bottom
of the K-Cup
®
Pack Holder. To avoid risk of
injury, do not put your fingers in the K-Cup
®
Pack Assembly Housing.
6.
Lower the Handle to close the Lid over the
K-Cup
®
Pack Holder. (When it is closed
completely, the LCD Control Center will
indicate “READY TO BREW” and the Small
Cup, Small Mug and Large Mug Buttons will
flash for up to 60 seconds.)
fig.
4
fig.
5
fig.
6
fig.
7
8. The brewer will automatically fill the
internal tank with water and then the water
will be heated. This will take about 4 minutes.
During the heating period, the LCD Control
Center will indicate “NOT READY” (fig. 4). Do
not lift Handle during this heating period.
Once the water is heated, “READY TO BREW”
will be indicated and the Brew Buttons will be
illuminated (fig. 5). NOTE: You may see small
amounts of water coming from the Vent and
dripping into the Water Reservoir during this
and subsequent heating — this is normal.
9.
Lift and lower the Handle. Press the Small
Mug Button to start a cleansing brew. When
the brew cycle is complete, pour the hot
water into the sink.
10 . The one-time set-up process is now
complete and you are ready to brew!
NOTE: The brewer may take 15 seconds
between brews and then “READY TO BREW”
will be indicated.
dtp1005-001900 ctp09
P7 201309003 KER755_K60-65.pdf 1C( K) ZB2319 2013.09.06
Loading ...
Loading ...
Loading ...